I wanted to use the Raspberry Pi in this project because it is a miniature computer that could replace the big laptop I use to control the vest. Originally, because I wanted to make another box, I made a Python program to control Adafruit 12 PWM port...
Connect the raspberry pi to your home router with an ethernet cable. Set a static ip address on the PI. At the prompt: sudo nano /etc/dhcpcd.conf Add the following lines for at the bottom of the file: interface eth0 static ip_address=192.167.1.106/24...
Next, you're going to get the SD card ready for booting the operating system on the Raspberry Pi. This begins with copying the official raspbian lite image to the SD card. This is a process that can be done in many ways, and it slightly differs depending...
Reconnected everything & there was obviously a major malfunction. There's either a dead board, broken wire, or a contaminated connector. The LCD was only driven 1 way instead of oscillating. There were bad columns on 1 side while the other...
After some kernel hacking, I was able to get the board to work with my Raspberry Pi!I made some measurements using Room EQ Wizard with the board looping the outputs back to the inputs. REW only seemed to work in 16 bit mode, so the THD+N measurements...