4801 Results for "%s"

2 PVC Cap(s)
Instructions from RTL-SDR Mobile Antenna Casing/Holder
Obtain 2 caps that fit the 3/4 inch pipe piece.

Reflow the board(s)
Instructions from TinyFPGA A-Series
If you have a reflow oven like the Controleo2, you can simply place your board(s) in and press start.If you have an electric griddle or hot-plate you'll need to keep a close eye on the solder paste. Start on a low temperature for the griddle and let...

Load font(s)
Instructions from TrelloBox
Using SPIFSS would be great, but current tools don't support Arduino IDE 2.0 yet. The easy way: load the Unicode-supporting TTF font to a microSD!

Test your board(s)
Instructions from TinyFPGA A-Series
Make sure your boards work! A simple bitstream that sequentially asserts each of the pins will help to ensure they are functioning correctly. Attach LEDs to the pins and watch that each LED lights up by itself and all of the pins light up at the correct...

Fathom-S topside assembly
Instructions from OSUG: Open-Source Underwater Glider
Cut a ~10cm length of the tether cable and strip it down to the pairings. Strip the ends and tin one end of each wire as shown below. Solder the other end into a breadboard and also solder an 8 pin male KK series connector. Make sure that the wires and...

Equipment s, materials and building
Instructions from Clean energy: Energy Conversion
Very easy

The PCB´s Are Here
Instructions from 5-12V Capacitive Touch Switch
8 days after ordering, the prototype PCBs finally arrived. They look simply great.

Then type 'cd Dylan-s-Drawing-App'
Instructions from Dylan's Drawing App

Optional: Solder pins to the board(s)
Instructions from TinyFPGA A-Series
The pins are through-hole parts and must be soldered by hand.

Enclosure(s) for food - 3D prints
Instructions from Smart Pet Feeder - Waylay IO
We have adapted the very nice 3D printed Servo Screw system done by this user on Thingverse. We only printed one for demo purposes, but you can print two to have different flavours of food or maybe food and water. We have used a plastic bottle to...

Circuit for amplifying thermocouple miniscule voltage, calculating S & A
Instructions from Thermocouple Amplifier
Normally without any amplifier the output from the thermocouple is in µV range. We need to amplify this voltage so that its easier to understand and read.A simple non-inverting amplifier configuration is used to amplify the miniscule voltage of...

Solder in the breadboard power rail header(s) (optional)
Instructions from RC Servo Adapter
Install the board with the signal header down into the breadboard and look through the holes over the power rail to see which ones line up. Pull it up, insert 2x1 pin headers in those locations (or location) and then put the PCB back down and solder...

Wiring and testing of Adafruit 's i2s microphones
Instructions from Smart earbuds
Make sure you set the raspberry up before this step and connected to your laptop via ssh. For the wiring and testing of the Adafruit mic you can follow these steps : https://learn.adafruit.com/adafruit-i2s-mems-microphone-breakout/raspberry-pi-wiring-test...

Connect to the ESP32's AP and upload the files from the 'micropython' directory
Instructions from Blinkencard - Pocket Altair 8800

Type in 'git clone https://github.com/blueOkiris/Dylan-s-Drawing-App/'
Instructions from Dylan's Drawing App

1
2
3
4
5
>
>|