27106 Results for "《 예약문의 OIO↗8489↗8306》청담가라오케П㈄delightfulセ가라오케가라오케νreflected 가라오케사이즈가라오케 가라오케추천㎙가라오케ｑbring㈀"

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Then use the Touchstone Dock as a template to trace the area to cut on the wall. Use a stud finder to make sure you are in an open wall bay.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Then cut your hole with a drywall saw (being careful of wires in wall, it might be a good idea to shut off power to be safe).

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Now test fit the charger and adjust hole accordingly. You'll want a snug fit to prevent drywall cracks later.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Leave the factory plastic on the Touchstone and cover the front of it in painters tape to give the drywall mud something to stick to.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Just add a single layer of tape, butting edges together to keep it flat and smooth.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Test fit again since the tape adds thickness you might need to saw the hole slightly larger.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
I took the end of an extension cord and wired it to power from the switchbox below to accept the plug-in charger for the Touchstone. I had a switchbox on the opposite side of this wall that could house the charger and keep it accessible for safety and...

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Add a wood backer strip with a couple of dry wall screws, a 1x2 or a paint stirring stick will work.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Test fit the depth once placed in the wall. Depending on your wallboard thickness it should sit just below the surface of the wall so you can use drywall compound (mud) to cover it.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Guide the cable so it doesn't get pinched and secure the Dock Stand to the wood backer. I used zip ties since I didn't want to damage the Touchstone Dock.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Now add a backer piece of wood above the Dock so you can screw the magnets to the wall securely. Notice I started mudding it in before I realized I missed this step.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Screw the wood backer in with some drywall screws, and then hollow out a shallow void for the neodymium magnets to fit into.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Screw two neodymium magnets to the backer wood, making sure to keep them just below the surface of the wall.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
I added some drywall mesh tape just where the magnets were just in case they might cause drywall cracking if the force was strong enough. Then start to spread drywall compound (mud) evenly over the surface pushing it into the cracks.

HP Touchpad Charging Wall Mount
Instructions from HP Touchpad Charging Wall Mount
Spread it smooth so you won't have to do a lot of sanding later, but you may have to sand and do another thin finish coat.

|<
<
3
4
5
6
7
>
>|