• It's alive!

    Carl Bugeja09/09/2018 at 23:07 0 comments

    This video shows my first attempt to create robotic fish fins made from flexible PCB Actuators!

    There were quite a few things that a learned from these experiments. The first prototype that i made did not actually work very good in water. Its magnet in the middle was too heavy when compared to the force the magnetic actuator was producing. The second prototype was much lighter and managed to move easily in water. It was still limited by the wire, but obviously this is going to be remove in the future version.

    From these tests I can start designing a 3d printed version that will house all the control electronics, battery and magnets.

  • Prototype Version 2.0

    Carl Bugeja09/08/2018 at 00:51 0 comments

  • Soft Robotics made from PCBs

    Carl Bugeja08/30/2018 at 17:13 0 comments

    The coolest thing about my magnetic PCB actuators is that I can play around with new robot ideas! In this video I have mentioned different type of soft robotic ideas I have, all from this technology. 

    This project page is about the robot fish concept.