Close

Week 7 - Design and Prototyping #2

A project log for Dynamic Interactivity

Urbanscape Malaysia Project

Austin ChiahAustin Chiah 10/31/2018 at 18:510 Comments

Meet and find object we needed 27/10/2018.

We found a really big problem. We need a stainless steel ball, but we can't really find one. 

We went to a lot of store such as, Mr. D.I.Y., car repair store, and hardware store. We even plan to buy a dog drinking water cap to just break it and get the steel ball inside. Anyway, we end up founded a Christmas decoration bell that not used for long time. We planning to break it and get the ball inside first for the prototype use.

Meet in class 31/10/2018

We meet in class and start doing our prototype. We mainly focus on our coding part, because we think that functions is more important for our alpha test. We did some progress such as laser cutting out our map maze, created the base and the hemisphere for the control, and some coding.

We did rethink again for the controls of our maze, because we did struggle a bit with the hemisphere at the bottom for controls of the maze. We might change or think of another why to do the controls for the maze.

After whole days of making and coding, we decide to meet again at 4/11/2018 in class again to continue and finish the prototype.

Discussions