You will need:

• 4x side stl

And depending on your driver choice:

• 1x apc or lpc stl
• 2x wago_apc or wago_lpc stl

Screw driver of choice to their base, using M2/M2.5 screws

Screw side pieces to driver base, use m3 screws and nuts, wait to tighten.

Screw led bars to the side pieces, without tighten to much.

Once all pieces are in places, make sure everything is firmly tighten

Screw the wago connectors and put them in place

Connect it as in scheme, add a bit of tin at the end of the cables that are going to the led bars, also you can add some male connector or you can add liquid electric tape over the connector to isolate them.

Connect it in a safe way, using other wago connector for example

Any photos of your build, veggies you raised with this or or remixes are very welcome :)