If you plan on painting parts, this is probably best time for it - before you thread in any wires, install any other parts and before you melt in heat insert nuts. Remember to sand surfaces, degrease them before priming and painting. I've used cheapest...
You could say installing a strap holder is optional, but it shows how to bolt it to a handle, and i think handle is too nice to be skipped. But there won't be many details because it is somewhat straightforward. You basically print strap holders, pass...
Grab both M5 x 20 bolts, align alpha/omega hinge parts together, apply washers to the external side and put on the wing nut: You can do this also with the hinge already installed on both keyboard carrier and primary case, but if you did not - do it now....
That should be it. Tighten the hinge bolt (the one without wing nut) and adjust the tension with wing nut only. Install the second handle to the back of the keyboard as a stand. Unfold the machine and behold.
Remove the cap over the neck ball joint Use the same small screwdriver to remove the two small screws holding the plate above the ball joint of the neck. We'll need access to this ball joint to attach a servo horn and servo in order to allow the head...
Let's have a look at the design of this TEMP Meter project, which was made in Fusion360. The first holder that we modeled is made up of an upper and a lower holder that are both going to be tightened to the handle of the motorcycle. This holder is attached...
Using two M2 screws, we first attach the basic lever component to the TEMP circuit. Two holes have already been created on the PCB for mounting the screws with the lever part.Next, we mount the lever part assembly with the upper holder using two washers...
We use four M5 bolts and nuts to mount the heating element. To hold the four bolts in place, we first set them in the correct spots and tightened them with an M5 nut on each of them.Next, we place a nut on each bolt.The heating element plate was then...