Close

1018 Results for "3D printing"

  • 3D Printing.

  • When we were sure about every feature in our design we started the 3D printing. It took us almost 17 hours to achieve our goal, but the wait was worth it. 
  • 3D Printing

  • With PLA the tolerances were very good in my set up; using PETG was not that good...  I adjusted the fit to the bearings by printing with a slight increase in size, defined in the slicer.
  • 3D Printing

  • First of all we should print all of the parts from 3D printer. In first try we used model from bq3D.
  • 3D Prints

  • First, 3D print the control box top and bottom as well as the indicator box front and back. While these are printing, you can start on assembling the circuit board as described in the next step.
  • 3D Printing

  • 3D print the required components. All files can be found at: https://github.com/Team-Automata/Modular-Universal-Jamming-Gripper/tree/master/3D%20Printer%20Files. Print all .stl files found in this folder.
  • 3D printing

  • Now the STL file should be sliced in favourite slicer (i used Cura) and 3D printed. The file can be mirrored before printing if necessary. I'm using some expansion options to make the holes and clereances a bit larger: Horizontal Expansion -0.04mmInitial...
  • 3D Printing

  • It’s going to be near impossible to make this model without a 3D printer, while it could certainly be done, I wouldn’t recommend it. I have included the .stl files I used below, using only a fraction of the files in the original Thingiverse post. Print...
  • 3D printing

  • When we had finished the satellite, we decided it would be nice to place it in its natural environment. That's why we decided to 3D print a model of the moon's surface.
  • 3D print instructions

  • Few instructions for the 3D printing of the provided housing. Preferably use PETG material for printing the housing and car holder because of its higher temperature resistance, which is advantageous for use in the interior of the car. For reference I...
  • 3D print

  • Start by printing the body of the camera system. It is a single piece with the dimensions of 95x22x177mm, capable of holding all the components. I printed it in PLA, but considering the heat developed by both camera and VTX, ABS is strongly recommended....
  • 3D Printing:

  • 3D print all the parts provided in the link below.3D Print 16 small button in white PLA and remaining parts can be 3D printed in any color you want.After printing all the parts install all the 16 white buttons in the array using some fast glue.
  • 3D Printing

  • 3D Print each of the components in the .zip file.  These include the coil bobbin (top and bottom), Speaker "cone", and speaker "back".  Be particularly careful when you pull the speaker cone off the bed!  I found that pulling the glass...