Use a solder iron with a fine head to solder the components onto the PCB. Recommend using fine tweezers for soldering the 0603 components and lead free solder. Please make sure to solder in a well ventilated area or using a fume extractor! NOTE: For...
Use a solder iron with a fine head to solder the components onto the PCB. Recommend using fine tweezers for soldering the 0603 components (and the 0606 flashing LED) and lead free solder. Please make sure to solder in a well ventilated area or using...
Prepare clock2a. Drill 6mm hole in Deltron 479-0160 enclosure2b. Super glue 3xAA battery golder into the enclosure2c. solder 3.5mm jack to wires and connector, heatsrink it2d. prepare PCB2e. populate PCB2f. Super glue PmodGPS module into the enclosure(note:...
Open the file "ibom.html" from the Github repo to help you place the parts. Assuming you are hand-soldering, solder the parts in the following order: Back side: Transistors, diodes, resistors, capacitors, regulatorFront side: Transistors, diodes,...
Solder jumper wires to five of the outer pins on each rotary switch, and a normal wire to the central (ground) pin. Solder wires to the toggle switch, one each to middle and one side pin. Solder wires to the pushbutton pins (if being used). Solder...
I tried to keep placement of the parts easy to understand, and in v0.2 I kept the values for the parts visible on the back silkscreen for easy reference. Hand soldering is best done with 0.4 mm no-clean solder wire (except for battery holder and pin)....
Solder jumper wires to all eight of the outer pins on each rotary switch, and a normal wire to the central (ground) pin. Solder wires to the toggle switches, one each to middle and one side pin. For each LED, solder a jumper wire to the LED anode pin,...
The position where you put the breakout modules onto to prototyping board is important. Solder the pin headers to the modules and place them in the correct position onto the prototyping board. Solder only one pin of each module and check if the USB ports...
Solder female headers on the side of the Feather board.You can decide if you would want the headers to go looking up on the same side of the keys so the Feather will be on top, but can also be attached to the bottom of the featherwing by connecting the...
Start with smallest (shortest) components first, then work towards tallest so that board can be flipped-over at each step to solder components in place without them dropping out. Suggested soldering order Resistors (no orientation)Op-Amp (Notch on Op-Amp...
Solder each pair of IR LED's and sensors to one of the single ethernet ports: red leads (+) to pin 1, black leads (ground) to pin 2, one yellow lead (sensor 1) to pin 3 and the other yellow lead (sensor 2) to pin 4. Solder a jumper wire to the corresponding...
These pcb NeoPixels have pads on their underside, therefore making it impossible to solder them to the flat service of the badge. To circumvent this solder some metal rods to the pads. Make wires a little longer to cut to size later for easier placement....
You must solder cables on the boards pads first than fit in the enclosure. Place boards in their slots, take measure for each cable, cut and sold.Those are the connections (or see the schematic in the attachments): 9V Battery : (+) => Digispark Vin,...
Electronic components must be soldered to the custom PCB. Additionally, a four pin connector to go between the ESP32 board and the micro:bit must be created. This can be seen as the ribbon cable in the project images, and includes a VCC, GND, RX, and...