Close

1859 Results for "《 예약문의 OIO≡⑧④89≡83O⑥》강남드림ㅮ강남드림within강남드림드림레깅스룸강남드림레깅스룸horrid 드림레깅스룸ギ∑드림레깅스룸thorough"

  • Universal Controller
  • Instructions     from Universal Controller
  • Solder up the AVR + regulator onto a perf board, according to the schematic.  Include programming headers (MOSI / MISO / SCK / RESET) and a 6 pin breakout for the PS2 controller wires you soldered last step.The schematic for this is below:

  • Animatronic AVP Predator cannon

  • Instructions     from Animatronic AVP Predator cannon
  • Cannon code- #include "Servo.h" // include the servo library Servo armServo; // servo to raise the arm Servo cannonServo; // servo to recoil cannon // these constants won't change: const int triggerSensor = 1; // the sensor is connected to analog pin...

  • Jewel Box Servo Meter
  • Instructions     from Jewel Box Servo Meter
  • Wire up the circuit. Use 3-pin and 6-pin  male headers to connect to the Digispark rather than wiring directly. This will allow easy disconnection of the Digispark for reprogramming. Optionally use a 3-pin header for connection to the servo in case...

  • Project: Lens of Death
  • Instructions     from Project: Lens of Death
  • Bend pipe into ring, bisect lengthwise into rings of halfpipe.Sandwich both sheets between rings.Drill holes equally spaced through sandwich.Apply ring of water seal between plexiglass, bolt, and inflate.If necessary, allow seal to dry.Deflate and inject...

  • Low Cost CO2 Laser Build
  • Instructions     from Low Cost CO2 Laser Build
  • PVC Cooling Jacket for CO2 Laser0PVC Cooling Jacket for CO2 LaserThe adventure begins while I was walking around the local home depot looking at ideas on how to build the laser. I was sort of making it up as I went. Mapping things out in my mind. I wanted...

  • Low Cost CO2 Laser Build
  • Instructions     from Low Cost CO2 Laser Build
  • Mirror Mounts0Mirror Mounts… where to begin, in many ways… these are the make or break it for this project. These have some very high tolerances and requirments. Especially considering I am doing this all by hand, after all, the goal of this project...

  • Low Cost CO2 Laser Build
  • Instructions     from Low Cost CO2 Laser Build
  • Assembling the tube1And now for assembling the laser tube itself. Things needed for this will be a bit of JB weld, a long thin dowl that fits inside your mirror mounts. This will help align them, much better than eyeing it. You will also need some 3/8th...

  • DIY Variac
  • Instructions     from DIY Variac
  • After some looking around I got this one for 30 dollars.It was bare, but that is ok. I looked around for a container for it, and could not find one that I liked. I considered building one out of wood, but chose against that as well. One option was to...
Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday