Close

3734 Results for "↘ 최저가 Ò1Ò〈⑻⑷89〉83Ò⑥ ↗ 쓰리아워㏃ ㏐addition쓰리아워Ⅶ강남술집정보강남술집정보Ｏ Ч강남술집정보exhibit 강남쓰리아워к강남술집정보㎼Ŋmethod"

  • Make and Feel Virtual Drawings
  • Instructions     from Make and Feel Virtual Drawings
  • Make Processing control Arduino THE FINAL PROGRAM:So,you have started drawing on Processing. Now, you'll 'feel' the drawing!Imagine you are blind (remember, this device was invented for blind people to draw on computers):How would you feel a raised line...

  • Make and Feel Virtual Drawings
  • Instructions     from Make and Feel Virtual Drawings
  • Power to Servo motor So, we've written the code. Now start all wiring stuff:We have two options:Give 5V to servo motor from Arduino.Here, you can connect the servo motor ( attach a small fan to the motor ) to Arduino Uno. Servo motor has 3 wires: Connect...

  • Make and Feel Virtual Drawings
  • Instructions     from Make and Feel Virtual Drawings
  • Hack a mouse (optional) Open the casing of the mouse, and remove the scroll roller.Now, you should have space to place the servo motor like in the picture.To paste servo motor on the mouse board, use a glue gun or double sided tape.Now, there should...

  • Experiment Bioroid!
  • Instructions     from Experiment Bioroid!
  • Neodymium Magnets mountingDrill 2.9mm holesuse 5 magnets for each hole in blue base and hemisphere.glue only the last magnet to hemisphere.  

  • Jewel Box Servo Meter
  • Instructions     from Jewel Box Servo Meter
  • Program the Digispark and temporarily connect the servo to test the software and servo. I had a batch of 5 identical servos. Two of them rotated contuously when the Digispark was reset. The other three worked fine. One of those three was very jittery....

  • Jewel Box Servo Meter
  • Instructions     from Jewel Box Servo Meter
  • Test fit all the components in the box to find the best arrangement. Cut a piece of strip board 8 rows wide and up to about 25mm long that will fit flat on the floor of the box. The strip board will act as a bus to connect to the header. I placed the...

  • Jewel Box Servo Meter
  • Instructions     from Jewel Box Servo Meter
  • Bend the pins on the header at a right angle. Drill 8 holes 1/16-inch (1.6mm) diameter in a line spaced 0.1-inch (2.54mm) on centers. Pass the pins through the holes with the header on the underside of the box.

  • Jewel Box Servo Meter
  • Instructions     from Jewel Box Servo Meter
  • Temporarily put a jumper between ground and the input pin on the header under the box. Turn on the system. After a 5 second delay the servo should move to zero then full scale then back to zero.  You may have to adjust the mounting of the pointer...

  • Portable LED Floodlight
  • Instructions     from Portable LED Floodlight
  • Build a tripod. You may have to re-stock materials at this point. Might I suggest a stout? Always goes with metal work.I started with a halogen work lamp which was at the end of the line.. yanked the 15" legs off and replaced them with 4ft pieces...
Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday