Are you searching for the perfect OpenWRT device with robust Hotspot 2.0 and Passpoint 2.0 support? Look no further! We’ve curated a list of highly recommended devices that seamlessly integrate these advanced features into your network. From the GL-MT6000...
In the /etc/config/wireless file, customize the settings for your Hotspot 2.0-enabled interface. Ensure the correct device, encryption type, and other parameters are set. Pay attention to the WAN Metrics, NAI Realm, and Domain Names sections to tailor...
Open the outer casing of the ASONPAO IntelliCode remote, remove the board (it has no screws - it should lift out), and remove the CR2032 battery. Next to the button you should see four open pin holes: the one with the white box drawn around...
Here's the code that was used in this project, and its a simple one. This code essentially demonstrates how to use the AHT10 sensor library to read temperature and humidity, display the results on an OLED screen, and handle errors. The delays between...
The next step of this project was to put everything together to create a basic PCB that would contain all of the components we used to create the breadboard version, in addition to a lithium cell with a charge discharge circuit to power the XIAO module,...
Let us now analyze the main control circuit. Three sections make up this circuit: the XIAO M0 Microcontroller section, the MAX6675 Setup, and the AC section, which is connected to an isolated SMPS and relay. Let us begin with the primary part of this...
Here's the code used in this build: const int LED = 0; const int threshold = 150;//cuttoff temp MAX6675 thermocouple(thermoCLK, thermoCS, thermoDO); void setup() { display.begin(SSD1306_SWITCHCAPVCC, OLED_ADDR); pinMode(RelayPin, OUTPUT); pinMode(LED,...
This was the previous Hotplate project, which expanded the heating area by connecting the cloth iron's element to a copper plate. A mechanical mechanism called a thermostat was used to control the heating element of the original version of the hotplate....
To update the TOTP authenticator you need the following: * A authenticator with the dfu bootloader installed (prebuild bootloader can be found here. * Dfu util * New software To install the new firmware follow the following steps: 1. Hold the "enter"...
The clock can be built in 4 or 5 meetings with kids. Recommend ages 10 - 18. Younger kids will need more help. One person can handle 8 - 10, with more you will need some help First meeting 1. I talk about what an...
Second meeting 1. Hand out the Arduino, RTC module, wires, alligator clips, USB power block and USB cable 2. I ask them how we are going to have the Arduino control the meters ? I explain what PWM signal is and how we can use...
I recommend splitting the group up into two sections. A lot of prep work is required for this meeting. You need to have milled all the faceplates (hours and min), I made a couple of extras. The plywood boxes also need to be lasered...
If you were able to get all the magnets glue in at the third meeting everything will be wrapped up at this meeting. If you were not able too, then we will need to have a short fifth meeting. I do the same steps as the Third meeting. Skip...
We are going to put shellac on the box. 1. Again give everyone wax paper and set of rubber gloves 2. I use Bulls Eye Shellac Clear. 3. I use a paper tower to spread it around. 4. Have them do each side. They...