Close

27106 Results for "《〈 문의 OIO↗5793↗7458 》〉 강남몰디브ㄿ 《〈 문의 OIO↗5793↗7458 》〉 ㄻaudienceピ몰디브가라오케신사동몰디브шshop 신사동몰디브강남몰디브가라오케 강남몰디브ら신사동몰디브♩safely⒞"

  • Floating, Bamboo Makerspace

  • BOAT GEARSometimes when building a crazy idea, like a homemade floating laboratory, you can forget that there are lots of basic supplies you need just for being on a boat. Thus things like:Life jacketsFirst Aid kitsTrash CansSnorkelswaterproof cameraswaterproof...
  • Nintendo TV

  • Put it all together. I installed the Pi and added an adhesive square to the Pi's case, and loosely ziptied it to an internal part of the TV to keep it from moving around too much. Plug a USB adapter into the outlet you added and use a micro USB cable...
  • Step 2: Build voltage dividers

  • I used a standard USB-A connector that would plug into the QC3.0 port on my power bank.  I just cut an old cord and re-used it.  The black wire is ground, red is positive, white is the "D-" line and green is the "D+" line. I used...
  • Restart and test

  • Now you can safely restart the ninHOME Node and hopefully it will drive the Display and reacts to the Topics you specified. You can test it if you use the mosquitto-tools to send a message to the display topic. For example:mosquitto_pub -h test.mosquitto.com...
  • Build Your Solar Array

  • There a lots of different ways to build an off-grid solar energy system, and many of them considerably cheaper than the method described here, if you know what you're doing.This system is offered because it is easy, safe, reliable, and requires zero...
  • Check for Shorts

  • It is important that you check if there are any shorts on the PCB before plugging it into your computer. As chips these small are usually found with soldering defects like bridging between pins or worst, short circuiting your VCC (5V from the USB) to...
  • Connecting Battery

  • Begin by soldering the battery wires and header pins onto the XIAO ESP32 board.Use the above pin diagram for connecting battery.Since the XIAO ESP32 board comes with built-in battery charging circuitry that includes overcharge protection, you can use...
  • Powering up!

  • After the writing process is complete, safely eject the SD card from your computerInsert the flashed SD card into your Raspberry Pi.Connect your Raspberry Pi to a power source. If this is the first boot, it will take a bit longer as the system expands...
  • Connecting the AUV to the ASV

  • To connect the AUV to the topside ASV, two tethers were used. One was an ROV tether developed by Blue Robotics (which can be found here https://www.bluerobotics.com/store/cables-connectors/cables/fathom-tether-nb-4p-26awg-r2/) and the second was...
  • Floating, Bamboo Makerspace

  • DesignThe lab is designed for modularity. The current incarnation consists of four re-configurable 3x4 meter platforms. If one is damaged, it can be taken out and repaired while the remaining lab continues to function. These modules can also function...