The functions for the servos will be very easy if you learned how to properly use them from step 3 so I will not spend much time on them. I will say however you will probably have to adjust the delay time and the angles they are turning. Do not...
Scrap all parts off the bulb holder including the wing-like metal airflow thingies (you will have to be a bit rough and break that parts) and the mirror. You should by now have a clean metal slate with a large hole on the top and some smaller holes on...
Here's a functional program to initialize the hardware, read temps, and display temps as colors. Enhancements such as multiple sensors/LEDs per Trinket are possible but left as an exercise for the reader./* trinket_thermo ---------------------------------------------------------------------------------...
OS: Raspberry Pi OS Lite Install the OS Download the lastest OS from https://www.raspberrypi.org/downloads/raspbian/Use Etcher to image a 2GB or larger SD card. Configure Wireless Access https://www.tomshardware.com/reviews/raspberry-pi-headless-setup-how-to,6028.htmlSetup...
Use the negative points of the button and connect to the gnd pin of the arduino.Use the positive pin of the button to analog pins A3 and A4.Use the positive pin of the pedal to analog pin A2.
The Arduino code is incredibly simple, with some strange looking oversampling for preventing the motors from vibrating:void sampling() //Oversample the slider readings to avoid motor vibration. { i=0; val =0; smallVal=0; while(i
Setting Up the EnvironmentRedtree Hydra currently requires a Ubuntu or Debian based development environment. For the remaining instructions, open the terminal application in Ubuntu. In Ubuntu It can be found by clicking the Ubuntu search icon on the...
Open main\bt_app_av.c Replace the function void bt_app_a2d_data_cb(const uint8_t *data, uint32_t len) with the following code: void bt_app_a2d_data_cb(const uint8_t *data, uint32_t len) { size_t bytes_written; uint8_t *mydat = malloc(len); if(mydat ==...
First, let's assemble the extruder, so we can just drop it onto the printer later! There are two sets of spacers, labeled B1-B7 for the Bottom assembly, and T1-T2 for the top assembly. There is also an extruder motor shaft coupler spacer, labeled...
Next, you're going to get the SD card ready for booting the operating system on the Raspberry Pi. This begins with copying the official raspbian lite image to the SD card. This is a process that can be done in many ways, and it slightly differs depending...
Next step is to wire all the source leads on the MOSFETs together (the right lead when you're looking straight on at it), and also wire them to the one 2-pin female headers on the lower left side of the board (which will be connected to the positive...
Time to start putting together the low-side driver board with the CAT4101s. First step is to install the connector on the 11 x 8.5 cm protoboard. This is the spec'ed component, but if you can't find one that size, you can use another one up to 11.5 cm...
Let's start at the top with the lift kite An HQ KAP foil lift kite is a good steady lifter ... not so strong pulling as a single skin but stable. Practice with these so you are comfortable with their use before you attach one to a turbine. Make sure...
In this step we will add the video module and optionally the sound module at that point you'll be able to run demos and games written specifically for this setup. Unless you want to run MSX BASIC or MSX games then you may want to stop there. RC2014 +...
You can find every information about Feather MO Adalogger in: https://learn.adafruit.com/adafruit-feather-m0-adalogger/overview I have used all pins of Feather and I would like to have more pins available. These are the connections of the set: Pin00-...