Connect FSRs, LED's to Ardunio Uno based on this fritzing diagram. Note: The "A0" pin is the analog pin which allows the FSR to communicate with the Ardunio Uno. More detailed step by step instructions for wiring will be posted for those that are just...
Plug in the 68000 processor and minimal glue logic. To test if you build this part of the circuit correctly, add 10k pulldown resistors on all 15 data lines of the processor. Power on the board, and verify with an oscilloscope that A0 operates...
Print enclosure and file down inner tracks so that the joystick PCB slides in easily De-solder pins from joystick breakout board Use wires to make the following solder connections: Solder GND on Joystick to GND on Arduino Solder 5V on Joystick to VCC...
In this step, we will complete the Transmitter setup. We will do the circuit part first and after that, we will upload the code to the Arduino UNO to wrap up the setup. The materials required for this step are the NRF24L01 Transceiver module, Arduino...
The platform's construction is complete. However, our project still need code to function. This code should be uploaded to Arduino:#include //defining Servoss #define TOLERANCE 10 #define STEP_DELAY 7 Servo servohori; int servoh = 0; int servohLimitHigh...
First prepare all the parts for final assembly. Solder the pins to the Nano board if needed then install the Nano board to the I/O expansion board. Then, attach or solder the jumper wires to the button switch and the buzzer. I used some leftover servo...
Set up the hardware - the emulator main sketch shows the pin layout: // // SD+Ethernet Shield (optional) // #if defined (SDCARD) #define SDCARD_CHIP_SELECT 4 // // software serial interface for Emic 2 TTS module (optional) // #if defined (SPEECH) #define...
First, connect the 4X4 keypad to the Arduino; connect the first six pins on the 4X4 keypad with the A0 and A5 pins on the Arduino. Then connect the last two pins on the 4X4 keypad module to digital pins 3 and 2 on the Arduino. After that, connect the...
Program LinkitOne to Control the Coffee cup using Bluetooth android app.Attach the LM35 temperature sensor to A0 pin, Transistor base switch and Bluetooth antenna to LinkitOne.Thus LM35 reads the temperature and send it to android app through Bluetooth....
Connect the two pins from the Sensor to the two pins on the Amplifier circuit via hook up wires. Connect the Vcc from the Amplifier to the 3.3V pin on the Arduino and the Gnd pin to the Gnd pin on the Arduino. Now connect the Analog Data Pin to the...
Make the following wiring connections: Connect the VCC pin to +5-volt pin of the Arduino board.Connect the GND pin to the GND pin of the Arduino board.Connect the OUT pin to the A0 pin of the Arduino board.
1. Connect buzzer to D7 and Ground2. Connect button to D6 and Ground3. Connect potentiometer to A0, 3.3v and Ground4. Connect battery to VIN and Ground5. Upload the code6. Print the case front7. Fit inside an Altoids can and you are ready
moThe big black device in the middle of the printed circuit board (PCB) is the speaker (aka buzzer, or transducer). You can see a little slit in the one side where the sound comes out. There is a back side to the circuit board that you cannot easily...