1. Connect the hardware as depicted on second image 2. Download the sys0800.bit file 3. Set all switches on the baseboard to "off" (== closer to the edge of the board) 4. Use https://www.micro-nova.com/mercury-programmer to upload the .bit...
To modify a Quartex Q-80 movement, first obtain the Q-80 variant crazy clock board. If you make the boards yourself, you must get them made with 1mm thickness. 1.6mm, which is the "standard" thickness, won't fit properly.
Ethereum & CitizenWat Installation on a Pine64+ boardPre-requisitePINE64+ under Debian Jessie (image : Debian Linux Jessie with Mate GUI Image [20160701] by lenny.raposo with Longsleep kernel (link).It is necessary to execute the following scripts at...
Obtain a clock movement or remove the one from the clock you intend to modify. The recommended clock movement if you wish to start with a fresh one is the Quartex Q-80, available from Klockit. It's also the movement being used (at least at present) by...
Test your web connection. By default the code puts sensor at 192.168.1.241 port 80. Open your browser and connected to the device. You should see a page similar to the one below.
I've had comments regarding the validity of using Geiger–Müller Tubes for a cosmic ray (muon) detector. Pointing out that Photomultipliers and scintillation panels are best, and yes the are far more effective. However, they are also expensive,...
De forma paralela a la banda, alejado con respecto a su centro y el borde de la banda a 80 [mm] y con sus perforaciones traseras en línea con la de fijación de la banda.
Wire as follows: Both potentiometers Pin 1: 5v Both potentiometers Pin 3: ground Left potentiometer Pin 2: A0 Right potentiometer Pin 2: A3. Note that they have two channels, and all three wires have to connect to the same channel...
get a 2 GB microSD, FAT formatted. (I think 2 GB is the max the driver will support; haven't tested with larger. Anyway, I suspect 2GB might be able to hold all the software ever written for the TRS-80, ever. UPDATE: it works with up to 32...
Move camera under model and select Bottom Polygons with Right Mouse Button Then select Move Tool and set Y to 50 Select exactly the Foundation copy Then open Scale Tool and set X and Z to 80