Announcing a major new capability: CylinDraw makes for an excellent paper plotter! The hardware needed to enable this capability only requires the addition of a large tube to wrap the paper around and two rubber bands to secure the paper in place....
YouTube How to update CircuitPython firmware This method is suitable for the BPI-PicoW-S3 board that already has tinyUF2 firmware. If the flash of the board is erased or the failure to enter the UF2 mode occurs, you need to refer to the method of burning...
I'm going to create a stand-alone PSoC project to use the PSoC to read SD cards. I'm going to start with the hardware defines for this project (which should leave the Z80 hardware pins unmolested) and just not download code. For the software piece, I...
Today, i rewrite a code of ambient light of arduino module applied FastLED library carefully. Why? there are 3 important thing, 1) the legacy code of adalight is based on SPI that is used by a RF module too. I think move pin in code of adalight from...
See Update BelowContext being more that of the puzzle of cases not one case "to rule them all," but I digress. The past week I've been going through a few catalogs to find an enclosure for D-DAQ's mainboard. Previously, the PCB's form factor was based...
Note: this log is obsoleted by BitsliceAfter the last log Adder with Falstad, I also converted the ROP2 bitslice to the interactive simulator : There is still the challenge to disable the output of the CLA so it can be combined by ORs with the rest...
One last thing that was still missing was the symbol table. Apparently the output of the softmax layer maps directly to the symbol table, and since this output is 128 in length, I was searching for a table of this same length.The prime suspect was of...
In this post I want to share how I selected a suitable topology for the resistor network that will be the core of the programmable decade resistor. Although I did some online “research”, the following criteria determined my choices: Switch...
My friend Dylan Brophy inspired me to investigate the ability to output the cyrillic text using different output devices, supported by Terminal-BASIC. 1. Using symbols others then capital latin in identifiers not possible and unnecessary. 2. USART output....