In this project, we will build a 2.4GHz Wlan scanner using the nRF24L01 radio board. In this project, the output delivers all the interference and information in the scanned area in the form of ASCII codes. In the project of making this scanner,...
3-11-2024 See these two 2011 Liliputing and TechCrunch articles, which were partly the inspiration for this project: https://liliputing.com/pixel-qi-suggests-low-power-tablets-could-be-powered-by-1w-solar-panels/(6-3-11) https://techcrunch.com/2011/06/04/first-solar-powered-laptop/ (6-4-11)...
Attaching a SensorIn order to attach a sensor, motor, camera or other component to the Redtree Hydra, the FPGA inside must be programmed. We know that this is normally a tricky task, so we created a tool to simplify it. The Redtree Hydra has four I/O...
Licencing and IPAll codes/scripts are hosted at: www.MichaelRatcliffe.com/projects[Will be updated before the 22/9/2015]Everything is released as Copy Left, For more info:>LicencesProject Prefaceabout me: Graduated with a Degree in Mechanical Engineering...
Next we will prepare the water flow. I decided to use this combination of pump and tubing, because they fit without an adapter. Other combinations work also. Clear tubbing isnt the best solution, because algae will grow inside the tubes. you can prevent...
Hi, this is the result so far from my larger-scale training run (see here). Unfortunately, it wasn't quite as large-scale as I hoped due to problems with the color-spaces and sizes of images from the caltech-256 dataset. The training run entailed the...
There are designs on the net for this, but they all seem based on a design with a fundamental error. They asynchronously reset the 8-bit counter when it reaches 207. This means it cycles through states 0 to 206, then very briefly becomes state...
Started to debug the code. So far the SNES controller reading is fine, operating mode selection is fine, Left port driving is fine.For this project I have used variables to store the state of the input controls and for the output data to interface with...
The boards have finally arrived. The past 12 months have been a mixture of waiting for parts, software design for FPGA IP Cores (harder than expected) and communicating to a thankfully perceptive PCBWay for fixing possible part conflicts with my BOM....
Crazy cool finding for the Kria SOM: if you save the settings from simulation of another GTH capable Zynq MPSOC (Like say the ZCU104 or ZCU106), you can load the GTH on the Kria SOM with these settings via dynamic reconfiguration, and have it working...
Today we present the FlameWheel Robot assembly tutorial and quick-start guide! It is rather difficult to assemble this robot without guidance. Feel free to refer to my introductory tutorial today.Flamewheel (A 2WD Remote Control Robot) is part of our...
Today I successfully tested assembled 4-bit ALU (previous revision of NEDONAND-4 board with four NEDONAND-1 connected). In order to do this I slightly modified the board to connect nedoCPU-16 with it: Then I wrote a simple program in PIC assembler that...
The story so far... Update: Row scanning working.Known/working: Building and loading via JTAG new firmware into the main FPGA. This firmware is starting from scratch, we don't understand much yet about the default Barco firmware, although we've dumped...
Slide the Pi Zero through the PiHolder, with curved tweezers carefully guide the jst connecter and the camera cable through Buttonholder piece and the front bridge piece.
This is a big question, where to start with the ESP8266. There is the official SDK path, for the brave. There is the Arduino, Espruino... Well, I tried NodeMCU. Starting with this page https://nodemcu.readthedocs.io/en/master/, there is a lot explained...