60 Results for "《〈 문의 OIO↗5793↗7458 》〉강남초원의집㉩⅓everythingァ강남유흥강남룸㏁evidently 강남초원의집강남더킹 강남더킹‡강남룸Ⅹfaintly㈆"

NANDfarm => RFarmer
Project by Radu Constantin
Small, easy to use, cheap ZigBee developement board for the internet of things.
- 2.5k
- 41

IV Warming Pod- Field Ready
Project by John Loeffler
Using Cheap, Stackable, rechargable and Readily Available Components to warm IV Solutions.
- 11
- 13

8 Channel Data Acquisition System
Project by piplay
An 8 channel differential input data acquisition system built as a Hat for a Raspberry Pi
- 4
- 5

Back Drive-Able Linear Actuator
Project by Sean Cain
Linear Actuator that uses a cable drive.
- 1
- 1

Roomba RPi
Project by Josh Gadeken
iRobot Roomba 690 enhanced with a Raspberry Pi Zero 2W and IMU.
- 338
- 35

Save RAM hack for NEC handheld consoles
Project by killua
Adding same RAM support to TurboExpress and PC Engine GT
- 3
- 2

MuDRA - Multipurpose Domestic Robotic Arm
Project by Sagar Sanjay Shenoy
MuDRA is a 3+ DoF non-mobile robotic arm that can be attached to any hard surface and assist in household work or as a stand to hold things.
- 4
- 5

Baffa-1 Homebrew CPU Minicomputer
Project by Augusto Baffa
The Baffa-1 is an 8-bit CPU created from scratch using 74 series logic gates and built using custom printed circuit boards.
- 33
- 38

Raspberry Pi Synth
Project by Stephan Bourgeois
The synthesizer is composed of three basic parts. There are two midi control boards based on the TM4C123GXL launchpads and a raspberry pi.
- 2
- 4

SecSavr Select [gd0091]
Project by kelvinA
Compact filament selector for 8 FFF printer filaments.
- 0
- 0

Review 015: RoyalOHM 10K Ohm Carbon Film Resistor
Project by Electorials
A review of the RoyalOHM 10K Ohm 1/2W 5% Carbon Film Resistor from Tayda Electronics.
- 2
- 1

Balancing Trike Robot
Project by Sean Cain
8 Axis Balancing Robot to put the Real in Mixed Reality.
- 135
- 0

Propeddle: Software-Defined 6502 Computer
Project by Jac Goudsmit
A single-board computer kit with a 6502 controlled by a Propeller.
- 1.3k
- 51

Pulsed Capacitive Discharge Power Supply
Project by Jakob Wulfkind
Pulsed-discharge power system suitable for welding, plasma cutting, laser driving, and other high-power equipment.
- 47
- 7

Icepick Delta
Project by TTN
A highly experimental open-source 3D printer with a rock bottom bill of materials
- 236
- 83

1
2
3
4
>
>|