57 Results for "solder fume extractor"

ViaConnect Circuit Board Test Tool
Project by David Spinden
Have a via on a circuit board that needs to be tested, but can’t or don’t have a connector? just use the ViaConnect.
- 34
- 34

Sugarcube - a tactile music controller
Project by amandaghassaei
The Sugarcube is a portable controller powered by Arduino that allows you to interact with MIDI and audio in playful and intuitive ways.
- 2.3k
- 105

Turtle Prototyping Solder Board
Project by Bits4Bots
180 tie-point solderable breadboard for electronics. Entry level soldering for kids in STEM.
- 1
- 1

Turtle Prototyping Solder Board
Project by Bits4Bots
180 Tie point solderable breadboard for electronics. 60mm x 70mm
- 148
- 1

MAP4
Project by Anool Mahidharia
a Blinky badge for the Maker's Asylum hackerspace in Mumbai
- 5
- 5

Kaleidoscope
Project by Eddie
A plant-like sculpture made from RGB LEDs, Warm White LEDs, and current limiting resistors.
- 24
- 38

DB25 IDC26/Header Breakout Board
Project by Mark Pickhard
Connects up to one each of D-Sub DB25M, & DB25F, IDC26/Header
- 1
- 0

12″ Raspberry Pi, Arduino, Electronics PCB Ruler
Project by Ian Dunn
A 12″ PCB ruler featuring the Raspberry PI 4 GPIO pin out, Arduino pin outs, and commonly used electronic components all in one place!
- 2
- 0

PTlogger
Project by gruenst
Mobile and waterproof temperature logger for three PT100 / PT1000 sensors with SD card and OLED display output based on Arduino and MAX31865
- 4
- 2

Easy breadbording of 0603 SMD led / resistor
Project by ftregan
Beginner friendly way to solder 0603 or larger components to pinheaders so you can plug them in your breadboard. 2 minutes and you are done.
- 250
- 16

Snowbot V1.0
Project by Dan Hienzsch
A holiday project to build a little Snowbot with an adjustable speed larson scanner for an eye.
- 6
- 7

RLN Electro dev. board
Project by Artem Kashkanov
Development board compatible with Arduino software stack
- 0
- 2

36 Touch Sensor Matrix
Project by frankstripod
“These aren't the duinos you're looking for. You can go about your business. Move along.”
- 36
- 12

Reviving Old Nikon D1 DSLR With Li-Po Battery
Project by matteo
D1 users knows that old EN-4 (Ni-Cd) batteries are worth and offers only few shots.
- 1.4k
- 2

AtTiny brightness controll for 3d printer display
Project by Wintertod
Brightness controll of a Reprap discount full graphic smart controller with an attiny45
- 0
- 0

1
2
3
4
>
>|