Close

657 Results for "solder fume extractor"

  • IRM mini
  • Details     from IRM mini
  • Easy extension Solder pads on 4 sides, with both IN and OUT, makes it easy to extend IRM mini into a larger piece of display, whether with wires or just solder them together, it's your choice.SourceThis board is also Open Source!https://gitlab.com/tamctec/irm-mini...

  • Trombino
  • Instructions     from Trombino
  • For the wind version... Solder parts for the button board onto a small piece of stripboard. The schematic for the layout can be found in the Fritzing file on the projects github repository. Cover the back and sharp edges with Sugru.

  • 4R4C - FPGA Radio Challenge
  • Instructions     from 4R4C - FPGA Radio Challenge
  • Step 1: Solve the challenge.Step 2: Solder those 4 resistors and 4 capacitors to build the radio receiver on any piece of prototype board.Step 3: Connect your 4R4C radio circuit to proper FPGA and proper pins.Step 4: Design your Radio using Xilinx Vivado.Step...

  • 3D print
  • Instructions     from Model railway FPV
  • Start by printing the body of the camera system. It is a single piece with the dimensions of 95x22x177mm, capable of holding all the components. I printed it in PLA, but considering the heat developed by both camera and VTX, ABS is strongly recommended....

  • Current Status
  • Log     from NoteOn Smartpen
  • (Apologies for the lack of updates; some family stuff has prevented me from working on NoteOn for the last few weeks.)As of 2014-09-07, the IMU driver (which fetches data from the IMU and aux. accelerometer) has been completed, and prototype 2's defective...

  • Assembling densely populated PCBs with 0201 components
  • Hacker page     by Christoph
  • I recently assembled a tiny 7.5 x 9.5 mm PCB (actually two) with 0201 passives, LEDs, a BGA and a nasty LGA. Components on both sides. It was difficult, and I was not sure if could do it, but it went well with the right tricks and some experimentation....

  • CONNECT THE BATTERY
  • Instructions     from coin2pi
  • Solder the lower tab (the one with the bent up end) to B+ on the protection board. Make sure there isn't any unwanted electrical contact from the tab to the protection board. If so, insulate with tape or paper. Solder the wire from the top tab to B- on...

  • Revision 11 Update Log
  • Log     from Witcher Wi-Fi Medallion MK2
  • Minor compatibility fixes here: Board outline has been redone properly to ensure 100% compatibility between other programs, no more ugly null component hacks here.Ornamental backplate has been redone too to ensure compatibility between other programs....

  • Building the Frame
  • Instructions     from Seismometer
  • Cutoff two pieces of copper pipe 11" long, one 22", one 4 1/8", and two 1.5". Use a pipe cutter for this, it will make nice square edges.Drill a 1/4" hole through the center of the 4 1/8" piece for the eyebolt. Insert the 1.5" long pipe as connectors...

  • PCB Assembly
  • Instructions     from keezyboost40
  • Firstly, solder the diodes onto the board. You want the black bar (cathode) on the diode to face down for rows 1,2, and 3. For row 4, you will want the diodes to face up. This may change in future iterations. Once done I like to wiggle the diodes gently...
Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday