Plascii Petsma by Cruzer/Camelot has one of the nicest looking plasma effects I've seen for the C64. Since he included the source code, I was able to port it to the Z80 and TMS9918. On top of the features in the original C64 version, I have...
1. Toolchain not found After stepping away few days far from my PC for family reason, I resumed my activities on the Tsykuyomi project.So I started by reading the https://github.com/WHhkwong/SIPI_Bear_playback code and looking for a SNC7001A Toolchain/SDK...
MCP23017 Pins Used: PINWhat is ConnectedA0TCS34725 InterruptA1ADS1115 AlarmA2CCS811 InterruptA3VL53L1 GPIO1A4SI1145 InterruptA5VEML6070 AckA6User Button Active LowB0TCS34725 LEDB1User Red LED
Indeed, immediately after running the Windows software in a VM with the device connected I was getting a live data log of the CO₂ concentration! This screenshot shows me breathing into the vicinity of the sensor:Ok, time to disconnect the device from...
The rest of the boards just came:I think I will connect them together through wire-wrapped "motherboard" (lets call it "NEDONAND-10" ; )All of these NEDONAND components could be tested one by one using PIC microcontroller (connected to PC through RS-232)...
The 5.21E ROM works file with the current board, but the 7.11A ROM uses a different pin for the vertical sync signal. This can be fixed, but then the 5.21E ROM results in no display. Rather than fixing the hardware (with a jumper to be changed when the...
I took a perfboard and soldered up power and the data/address busses of the MCU, SRAM, NVRAM and the address bus latch.I did't really care about the exact order of the bits when wiring them up, I just went for the easiest layout. I'm not really sure...
Dyson V6 Setup and Running System Dyson handheld vacuum cleaners utilize high RPM brushless DC motors. Specifications indicate that some models can reach as high as 125000 RPM. I’ve disassembled DC56(V2), V6, and V10 models. Each has a brushless single-phase...