GoalsThe goal of this project is to emulate the Canon 600EX-RT Speedlite (via it's IEEE 802.15.4 protocol) and interpret the commands from Canon transceiver so that the Paul C Buff - Einstein light can be controlled with the Canon gear.CyberSync CSXCV...
There's a lot of small detailed steps to this setup, but most are common things you'd be doing with each component individually.. ie: setting up Linux on the beaglebone.. connecting solar to batteries, through the charge controller. This is all basic...
Mooltipass is composed of one main device and a smartcard.On the device are stored your AES-256 encrypted passwords. The smartcard is a read protected EEPROM that needs a PIN code to unlock its contents (AES-256 key + a few websites credentials). As...
This project is currently GPLv3 licensed.You just type voicecommand -e to edit the configuration file and add any speech and the coinciding command. You can see all of the little nifty commands it can recognize just with my config file in the video....
So my son, [B] did the soldering work. His uncle help him mill out the inside of the car to fit the electronics. [B] Drilled the holes for the lights and then painted the car with little sisters help. We tested the code on the MSP430 launch...
Arduino's SoftwareSerial library, based on NewSoftSerial by Mikal Hart, works pretty well for simple projects hwere you only do one thing at a time. But it keeps interrupts disabled during the entire byte plus start and stop bits. For reception,...
Interactive Disk SpinThe Interactive Disk Spin was born one fateful night when Paul took the cover off an old hard drive, started compulsively spinning the shiny platters with his finger, and then wondered "how fast am I really making it go?" Two late-night...
ideally, this sticks to a window, and measures noise levels through a piezo (contact mic). the other piezo is set up to knock. the rgb is for output. on this prototype, you can use the red LED for visual indicator.detail pictures show the traces running...
ED (Electronic Discovery) is specifically designed to engage a family with a friendly faced gadget which is easy to assemble, write code for and encourages them to interact. Ideally this makes electronics a family hobby rather than something Dad does...
This Project is to add a 2 watt laser module to the WaterColorBot.The Lasers power and controls go through a arduino.The laser will activated by a micro switch which is under the holder (the holder is where the laser and heatsink will be mounted)
Since I’m on a student budget, I couldn’t afford to leave an actual Arduino into my projects, so I designed, etched and assembled the BareDuino classic. I can quickly throw one into a project without having to worry about using an expensive regular Arduino.Using...