74 Results for "3D printing"

The Recreator 3D - Make Recycled PET#1 3D Filament
Project by Joshua R. Taylor
Strip down PET#1 Recyclable plastic bottles. Convert into new usable 3D filament. Load up your favorite 3D printer and recreate!
- 752
- 68

3D Printing with Brine
Project by Sam Mendel
We plan on using brine from desalination plants to print construction materials and make desalination plants have almost zero waste.
- 8
- 7

Beginner 3D printer (with off-shelf Electronics)
Project by vybhav-nag
3D printer designed for beginners, using off-shelf hobbyist electronic components (DC geared motor, arduino, etc.) That can be built easily.
- 207
- 3

WiFi Motion Sensor (3D print) - DIY
Project by Sylwester
We show how to build IOT WiFi Motion Sensor powered on a battery with email notification over IFTTT.
- 1.8k
- 13

3D Printed Flying wing FPV Drone
Project by K+
In this project, the objective was to build a FPV flying wing with over 700mm wingspan that could be printed under 24 hours.
- 825
- 18

LP3D: A fully lasercut kit 3D printer
Project by Luke Wallace
LP3D is an (almost) fully lasercut, low component count 3D printer with all linear motion components cut directly into the frame.
- 2.8k
- 50

Goats vs Llamas - a New Downloadable 3D Board Game
Project by jude_pullen
This game is an exploration of how much you can do by downloading a game - using both a paper-printer and a 3D printer.
- 4
- 6

Improved Allen Wrench / Hex Key Holder
Project by Alex Rich
3D Printed holder: Allen wrenches are held in a circle by a single o-ring, all individually accessible.
- 906
- 48

AI-driven Dental Cast Classifier w/ Edge Impulse
Project by kutluhan_aktar
Via Spresense; collect dental cast images on an SD card to train an object detection model, display video stream, and run the model directly
- 2
- 2

Apollo Saturn V and LUT
Project by wglasford
This is a 1/60 scale model of the Saturn V and Launcher - Umbilical Tower. This model is huge! I have been working on it for two years.
- 11
- 15

Easy Build my own useful Robot For Less Than $100
Project by Sergey Mironov
you can make your telepresence robot (Arduino based) if you go through the steps below
- 536
- 4

Chewed up remote repair
Project by Alex Rich
Dog chewed up old remote so I painstakingly designed and 3d printed a new case.
- 2.6k
- 27

OpenBreath
Project by Jose Ricardo
A 3D printable open source ventilator
- 6
- 6

mysoltrk - a solar tracker, reinvented
Project by Fulvio
A different approach for a solar tracker, alternative movements, to be installed on the outside, to optimize the efficiency of solar panels
- 249
- 62

DIY WallBox
Project by f4drj
Easy electric recharge at home
- 3
- 1

1
2
3
4
5
>
>|