Using a stock Ender 5 Plus hotbed. Plus a Keenovo 1000W AC Silicone heater: https://keenovo.store/collections/custom-keenovo-silicone-heaters/products/keenovo-silicone-heater-370mm-x-375mm-for-ender-5-plus-3d-printer-build-plate-heatbed-heating-upgrade Remember...
I tried to keep this project really simple to execute because it needed to be accessible to all the members of our hackspace. I have shared how I built the custom shaped PCB using simple to use open source software packages. This stage is no necessary...
The following tools and materials were used in this project: Tools and materials: Solder iron and wire. I had to solder some terminals to Nunchuk's wires in order to connect it to the Arduino;Shrinking tube. Some pieces of shrinking tube were...
The starting point of this positioning module is that we have three Infrared emitters located on three edges of a rectangle: Our robot is located somewhere in this rectangle: On the top of the robot a IR sensor rotates 360 degrees and detects the angle...
The standard operation of this device is to give the standard pulse to the speedometer as long as there is no deceleration measured. If there is a deceleration, a series of pulses will be generated that shows for 100 revolutions of the wheel...
In this IoT Internet of Things project, I have shown how to make the IoT-based water pump controller using ESP32 Blynk and float sensor switches. This water level monitoring system will also check the water level in both the overhead tank and underground...
In this IoT project, I have shown how to make IoT-based Smart Home Automation using NodeMCU Cadio to control 4 home appliances from the Google Home, Amazon Alexa App, and Cadio. If the internet is not available, then you can control the home...
Vectron VGA generates a 640x480@60Hz 3-bit color VGA signal and is designed to interface with the Vectron 64 6502-CPU based breadboard computer. It was built with 7400-series integrated circuits. The display is continually refreshed by the...
Components :1 x ESP-12 module1 x Custom made PCB or you can buy an Ready-made Relay board 2 x Power sockets1 x Acrylic sheet for casing Entire Project Files:https://www.dropbox.com/sh/3i9gks8z3caq7os/AABLyflO_m-40H-fA2qz7FNSa?dl=0Frimware:NodeMCUModes...
After a search & rescue for the rogue scrap pieces hiding, we tossed them in a pile on the floor and started our game of analog Tetris.We decided to use an IKEA Expedit as the base which is about 15.5" x 60" and give it a roughly 36" x 60" top. I had...
**Take care when screwing with a working and proven system!By modifying my printer I've sometimes unwittingly added small issues that weren't there before like: new Rattle on the X-axis, Over tightening screws holding down the Linear bearings. nothing...
The upgrades so far:Wireless DualShock controllable.Live streaming webcam mounted on X/Y axis servos to look around.Raspberry Pi to run the web stream and receive remote orders.Onboard boombox. Various software fun.
This project is a chronicling of taking a 1000mm X-Carve (first generation) and upgrading it to increase Y-Axis length to 1800mm and Z-Axis height to roughly double what it comes with stock. Nearly every component has been swapped out for longer, beefier,...