If you use four colors you will need four ink containers and one waste container. I used some empty jelly jars for that and drilled two 5mm holes into the lid to fit in the 6mm silicone tube. At the ink containers one tube is connected to the piezo pump...
You can use a piece of cotton or tissue and put little acetone on it. You don't need the industrial acetone I am using, Any acetone nail polish remover will work.After cleaning, I had to scratch some extra copper that didn't etch because of the misalignment...
The 2.9” active area contains 296 x 128 pixels and has 1-bit white/black full display capabilities. An integrated circuit contains a gate buffer, source buffer, interface, timing control logic, oscillator, etc… are supplied with each panel. You...
The 2.9” active area contains 296 x 128 pixels and has 1-bit white/black full display capabilities. An integrated circuit contains a gate buffer, source buffer, interface, timing control logic, oscillator, etc… are supplied with each panel.You...
The 2.9” active area contains 296 x 128 pixels and has 1-bit white/black full display capabilities. An integrated circuit contains a gate buffer, source buffer, interface, timing control logic, oscillator, etc… are supplied with each panel. You...
The Dyna comes with an E Stop switch that is connected in line with the input AC. As a result, no additional E Stop switch was necessary for this retrofit. If you want to connect another E-Stop switch, simply connect the E Stop switch to ground...
Once you've assembled the board, CAREFULLY insert the display's flex cable into the flex connector, and fold it over the edge of the board so that the display covers the documentation on the front of the PCB. You can secure it along the edges with Scotch...
Battery powering ESP-based devices always take some consideration, as WiFi, if not used sparingly, quickly sucks all the battery you can get. However, by having the device in deep sleep and only waking up for updates every n minutes makes it totally...
Take a look at the pin diagram for AMB23 and connect accordingly. Busy - D21 Reset - D20 DC - D19 CS - D12 CLK - D11 DIN - D9 The pin numbers definition can be found in epdif.h . #define RST_PIN 20#define DC_PIN ...
Not all CISS kits are the same, be on the lookout! If your kit includes a drill bit attached to a screwdriver handle, avoid it like the plague! That means they are going to have you drill into an original cartridge to supply the ink. These kits are generally...
We need to create articulating joints for our 3D scanned hand. I use the joint geometry of Steve Wood's "Flexy Hand" and integrate it into my 3D scanned hand model in Blender. You can also use e-NABLE's standard prosthetic hand models - in fact this...