PlayStation Classic Duo

Back to overview

Powered by Intel m3 Compute Stick

satri360

1
Setup Emulators in Windows 10
1. Install RetroArch
2. Run RetroArch
3. Load PCSX ReArmed for PlayStation Emulation
4. Install PCSX2
5. Install LaunchBox with BigBox (license required)
6. Run LaunchBox
7. Add Emulators
8. Add RetroArch and configure emulator to enable PlayStation
9. Add PCSX2
10. Enable Auto Login
11. Directly run BigBox by modifying registry
2
Modify Compute Stick
1. Open the case and take the m3 PCB out
2. Add external push button to the pad of PowerOn switch
3. Attach USB Type-A male connector to the USB 3.0 port of the m3 PCB
4. Wire +5V/GND to the USB Type-A male connector
5. Remove one of the HDMI connector from 2x ports side of the HDMI switch
6. Solder 19x magnetic wires to HDMI connector
7. Attach the HDMI female connector to the HDMI connector of the m3 PCB
8. Solder other end of 19x wires to the HDMI switch
3
Assemble
1. Remove the another HDMI connector from 2x ports side of the HDMI switch
2. Solder wires to each pin of the HDMI connector on the PlayStation Classic
  (You may skip 4x SHLD for TMDS pairs to reduce the wiring)
3. Solder other end of HDMI wires to the switch
4. Solder +5V/GND wires to PlayStation Classic Logic Board
5. Pack everything in the PlayStation Classic Case

Discussions