Close

324 Results for "《〈 문의 OIO↗5793↗7458 》〉강남초원의집㉩⅓everythingァ강남유흥강남룸㏁evidently 강남초원의집강남더킹 강남더킹‡강남룸Ⅹfaintly㈆"

  • Building the AUV - Internal
  • Instructions     from Project Albatross
  • The internals of the AUV performed the heavy work of actually taking water quality measurements and controlling the submersible's buoyancy. Evidently, it also required a sophisticated mechanical design to fit the necessary components into the confined...

  • Getting started
  • Instructions     from Projector Screen
  • Get and keep everything clean, including the back of your fabric. When you roll up the screen, the back touches the front, and any dirt will transfer right into the middle of your new screen. Take the actuator arm off the wiper motor. See what the threads...

  • Portable LED Floodlight
  • Instructions     from Portable LED Floodlight
  • Get yourself a box, and you put that stuff in the box.What I ended up doing here is mounting metal supports to the metal tripod pole. I then used lacing twine and laced the battery to those supports, the plastic bin is basically just sandwiched in there....

  • Step 2: build your own funny robot
  • Instructions     from Modular 5-bar robot
  • First of all, fix the servos bases to the base using the M5 screws and nuts like so. In case you are using the extra screws as support, place the larger ones on the corners as seen on the following image. If instead you are using anything else as support...

  • Switch
  • Instructions     from Electro Knife for Simulated Combat EleKSCo
  • Safety check: remove the battery. Take all the electronics from the previous step and push them into the handle, but pull the two switch wires out the drilled hole. The high voltage wires need to stick out of the end of the pipe by the switch. If everything...

  • Wheel Assembly
  • Instructions     from Upright Laser Harp
  • The stepper motor is secured onto the mount with two bolts. There is directionality to this mount; see the CAD model gif and video to make sure everything is in the right direction. A 3D-printed motor coupler connects the motor shaft and wheel axle....

  • Cylinder
  • Instructions     from Printing bones on a DIY powder bed 3d printer
  • Preface If you are lost or don't understand the guide completely take a look at the A360 site. Cylinder To assemble the cylinder you will first have to assemble the pistons. You will need 2 or 4 M6 threaded rods per piston. You will also need one nut...

  • MB Mounts.
  • Instructions     from The X-PC. Hackaday Prize 2022 Entry
  • When you are happy with the position of the MB, you need to mark the position of the 4 mounting holes nearest the corners of the MB.   Using a cordless drill with a 2.5mm drill bit., drill through the mounting holes - just enough to mark the screen...

  • Thermostat Hack
  • Instructions     from Thermostat Hack
  • Set up your cloudBits if you haven’t done so already. Instructions for setting up the cloudBit can be found here..2.  Connect your circuit:  USB power + temperature sensor + cloudBit + servo.3.  Adjust the template [Cloud Thermostat Cut...
Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday