Close

5943 Results for "↘ 최저가 Ò1Ò〈⑻⑷89〉83Ò⑥ ↗ 쓰리아워ㅾ Йlife강남술집정보ħ쓰리아워레깅스룸강남쓰리아워７┢강남술집정보indignation 쓰리아워레깅스룸ケ쓰리아워ı㎃outside"

  • Selecting a suitable oven
  • Instructions     from Reflow Oven
  • I went with a cheap toaster oven with quartz tubes on the top and bottom. Heater rated power 1000W was sufficient due to the small volume of the oven. Front panel You may select an oven with similar front panel to avoid having to cut anything. The software...

  • Slice and Separate Layers
  • Instructions     from Ear Savers From Garbage Masks
  • Chop out the middle part of the mask that isn't fused together. You should now have 3 layers that easily come apart. The middle layer is the troublesome layer! get rid of it! Collect the outside layers together. As far as I can tell, the only difference...

  • Attach the yarn guides and magnet
  • Instructions     from DIY Electronic Yarn Meter
  • Take your yarn guides and push them onto either end of the core of your tape dispenser.  They may stay put as-is, but ours loosened and flopped after winding a few balls, so we recommend hot-gluing them in place.  Also hot-glue the magnet to...

  • Build your own Facemask
  • Instructions     from COVID-19 Facemask
  • 1.      3D Print the mask. I suggest printing it upside down from its original orientation. This provides you with the easiest to remove supports. In my tests printing with the mask print with a rafting to prevent a misprint was required....

  • Set up your yarn
  • Instructions     from DIY Electronic Yarn Meter
  • Yay, you’re ready to test it out with some yarn!  Clamp your ball winder to a surface, like you would for winding any ball of yarn.  Set the tape dispenser in front of the yarn guide, so that the taped-over serrated edge is opposite your yarn...

  • Switch-pipe adapter
  • Instructions     from Electro Knife for Simulated Combat EleKSCo
  • We will start with the most exotic component in the entire build because it requires a 3D printer. If you picked a pushbutton with an exceptionally long threaded shaft, you might be able to skip this and mount your switch directly onto a chunk of pipe,...

  • Firmware
  • Instructions     from ESP8266-MQTT-co2-sensors
  • I have several devices flashed with Tasmota, and noticed it supports MH-Z19 out of the box, so that I flashed to the devices using Tasmotizer. Supporting this sensor required the image tasmota-sensors.bin, which can just be selected in Tasmotizer. ESPHome,...

  • Make temperature probe.
  • Instructions     from Outside Air Temperature Display
  • U1 will be mounted on the end of multi-wire cable that will be positioned outside to sense air temperature.  The cable should be thin in diameter so it doesn't interfere with closing the window and won't be damaged.  Individual wires in the...
Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday