Before we mounting everything in an enclosure, just make sure everything is working perfectly. Just turn ON your raspberry Pi3 and wait a 5 second to load everything. Press the button to take a shot using the camera and wait another second. You can hear...
The internals of the AUV performed the heavy work of actually taking water quality measurements and controlling the submersible's buoyancy. Evidently, it also required a sophisticated mechanical design to fit the necessary components into the confined...
No is the time to fit everything into the Head of the lamp. To fit everything in this Tight space you must DREMEL some pieces out of the Metal head. With a DREMEL this is done in around 5 min. Your Lamp Head must look like this before installing the...
Charge and connect the remote to make sure everything is working properly. Be sure to press on the throttle slowly to so you can make sure you wired the sensor wires correctly if they begin to spin up then stop let go of the throttle and check your wiring....
No need. CrowPi2 comes with a built-in image with a learning system! Everything has been prepared which means you can program and learn directly. Besides, with our CrowPi2 it’s easy and already integrated into the board as a STEAM platform ready to go....
Everything is easy to solder, I chose 0603 sized components and the 555 is a SOIC sized 8 legged chip. Before turning the "engine" ON, I would recommend to measure the voltages on the IC and control the right position of the coin cell battery.
Carefully place everything in the case and close the lid. Use some glue to stick the cannon on the servo. Place a rubber duck or anything you want on it.
1. Cover the cell with Thread to make it bit not ugly.2. Place all the components on perf board before soldering to make sure everything fits under the board size.3. Solder NE555 ic with other passive components including the tactile switch, then solder...
The first thing to do is to get rid of the 1/8 jack that came with the sensorThen I put some soldering in the end of the cable so it can be easy to stick it in the protoboardConnect everything as the the Fritzing Diagram suggestDownload the Arduino Sketch...
If everything is well, you will see the green LED blink for 5 seconds , Give it about 20 seconds to boot-up and check your WIFI connections in your computer. You should see the "Lamobo_D1_303510" as an access point