Section: 5A complete Laser Emitter AssemblyComponents Required: Printed versions of the following 3D Printed Objects from the gitHub repository: (1x) electronic_mount_laser_bottom(1x) electronic_mount_laser_top(1x) 532nm 150mw Green...
Section: 6A complete Filter Selector AssemblyComponents Required: Printed versions of the following 3D Printed Objects from the gitHub repository: mechanical_device_filterSelectorAssembly_frontmechanical_device_filterSelectorAssembly_backmechanical_device_filterSelectorAssembly_filterWheelmechanical_device_filterSelectorAssembly_centerHub_Backmechanical_device_filterSelectorAssembly_522nmSP_covermechanical_device_filterSelectorAssembly_550nmSP_cover(1x)...
Section: 7A Completed Spectrometer. A note might be made here that this spectrometer can and will function as an independant device connected to a regular PC running the ramanPi spectraCide software! If you wanted to use it and not build...
Section: 8Components Required:Printed versions of the following 3D Printed Objects from the gitHub respository:(1x) optics_module_testStand_laserWflangeA Completed Spectrometer532nm 5mw Laser PointerPocket FlashlightClick on the graphic above to...
Section: 10A completed optical Assembly including the Raman Section and the Spectrometer.Components Required: A completed objectiveLens MountA completed beamSplitter AssemblyA completed laserShutter AssemblyA completed mirrorMount...
The negative wire (green) is connected to the "in" side of the switch. you will want to also connect the wire to the copper pad you just exposed. The positive wire will be connected to the positive end of the Multivibrator circuit. the negative wire...
Build yourself a nice box, hopefully wired up better than I did above, and get playing. Some handy additions that I plan on putting in are:External access to the USB port for charging / syncingExternal LEDs (or make the existing ones externally...
WARNING! These instructions are somewhat premature and are intended to demonstrate the design for the hackaday.io prize competition. I'll be continuing to refine the instructions as I improve on the design and as issues crop up. Please get...
Set up and test Apitronics hardwareSet up the Apitronics Bees and Beaglebone Black Hive to make sure all the hardware is working. They should just work out of the box, but the firmware for both the Apitronics Bee and the Apitronics Hive are still...
Install the scale.The scale should be roughly level (beehives are often tilted slightly forward to keep water out, that should be fine) and fully supported on the bottom. The hive must be centered on the scale to avoid tipping.
Respect the hard work and dedication to a better existence given by the open source community. Thanks must go to Grasshopper 3d algorithmic modeling language for rhinohttp://www.grasshopper3d.com/And Thanks now in no particular order to...David...
Have a look to the Instructables page for the first prototype : http://www.instructables.com/id/3D-Printed-Camera-...The rework version doesnt exist yet. ;)
System Design:The circuit is very simple: LED Strip - Connect power to the LM2596 Step Down Adjustable Power Supply Module - ensure you adjust the pot so that the output is 5V; Connect the ground to the common ground; Connect data to pin D5 of the ArduinoTouch...