Step 7: Electronic ComponentsWe are now done with the mechanical set up of our longboard. Next, we need to wire up the VESC to the batteries and receiver. It is a very straight forward procedure. Before we start, make sure all connectors are compatible....
I am writing this expecting the reader to have a strong knowledge of computer hardware. You have been warned.The uPD7220 occupies two addresses in IO space and has an 8-bit data bus. There are also the WE and RD enables, but there is no chip...
The next step of this project was to put everything together to create a basic PCB that would contain all of the components we used to create the breadboard version, in addition to a lithium cell with a charge discharge circuit to power the XIAO module,...
STEP 5 – MAKE DESIGNNow you’ve got the overall dimensions you can produce your mimic. This can be done either by:Laser-cuting using a CAD file – this can be done on plywood or acrylic, the above design is translated to a package such as inkscape and...
First print out the full set of parts on 200-220GSM card stock. If you are using a dark coloured card, print the templates onto 85GSM photocopy paper and glue it to the card.Score all of the dotted lines well with a sharp point and a ruler. A ball-point...
For assembling of this harware we need a good knowledge in soldering of very small SMT components.Some SMT Pads, has a gap of only 0.2mm, see the picture bellow! The assembled unit must be tested with rDUNOScope Firmware and if it works, is fine...My...
Recommended tools and supplies Hot air reflow stationSoldering ironSolder pasteFlux penTweezers Component placement Start by soldering the SMD components to the board using a hot air reflow station. The names on the silkscreen (images bellow) can be...
Place the scuba mask face down on a piece of white paper and trace around the edge with a pencil or pen. Draw a line around the interior of this traced oval such that it is 3/8" away from the traced line ie smaller. Cut out this smaller oval - this is...
The manufacturing process of homemade PCB usually consists of the following steps: 1. PCB design In this step the drawing of the board to be produced is made. It is possible to both design a new board and make copies of opensource projects. Different...
I did this using the 3D pen method but i'll try to describe how to go about using a hot glue gun as well. Start out with one panel on the bottom, place the diffuser over the panel first if using them. NOTE: If you opt to use the diffusers...
You’ll need: A weighted tape dispenser with 1” core, similar to this one. A full roll of tape A digital magnetic counter kit Cardboard A pen or pencil Scissors or an exacto knife Phillips/Plus-tip screwdriver Pliers Hot glue gun and glueA hand...
With the skull upside down, place the jaw back in place. With a pen, make a mark where the screw hole should be drilled. Start by making a tiny hole where you think the hole should be and sticking a small wire through to see if you need to...
If you are planning on using the AAA battery container then you will want to modify the case to fit your switch. NOTE: This is just one way of adding a switch. Please modify as needed. 1. I used a Single Pole Double Throw (SPDT) switch that I pulled...
Upload the code and press the reset button once the upload is finished. Immediately after reset, the board will begin BLE advertising as “AMEBA_BLE_HID”. On your host device, go to the Bluetooth settings menu, scan, and connect to the board....
Upload the code and press the reset button once the upload is finished.Immediately after reset, the board will begin BLE advertising as “AMEBA_BLE_HID”. On your host device, go to the Bluetooth settings menu, scan, and connect to the board.You...