Plan out construction site. It helps to have snow on the ground, but is not mandatory. I used a 9.5 foot rope staked to the center of a circle to trace out the extents of my hemispherical dome. Note that my build was not on level ground, so I had to...
Step 1: Motherboard Assembly and ProgrammingI designed all of the boards to be hand solder friendly, with leadless QFNs all on one side (that can be reflowed). If the other side has components, these are usually larger and easier to hand solder. Step...
http://www.tricorderproject.org/arducorder/chipkit-mplab-ide-0023-arducorder.ziphttp://www.tricorderproject.org/arducorder/chipkit-mplab-ide-0023-arducorder.zipStep 3: Constructing the CaseThis beautiful case is constructed from laser cut acrylic --...
### [ WRITE IMAGE TO SD ]wget "http://93.174.101.10/bt/09bc05ab03780f279390e9cf6a15c7c249f712e1/data/2014-01-07-wheezy-raspbian.zip"7z x 2014-01-07-wheezy-raspbian.zipSD_CARD=/dev/sdX # Change it to your SD card device namemd5sum 2014-01-07-wheezy-raspbian.img...
For the controller and PIR the NRF24L01 uses the same pins to connect to arduino, Pin connections are,- Vcc - 3v3- CE - Pin 9- CSN - Pin 10- SCK - Pin 13- MOSI - Pin 11- MISO - Pin 12- GND - 0v- On the controller board you will need to connect to...
Now, you need to verify visually with LEDs the four outputs that should go to the H bridge, reds colors indicate forward, greens colors indicate backward, one red and one green colors indicate the turn left or right respectively. The control will be...
Once you have the correct programming of what will be the engine performance you need review the functioning and values of the MPU-6050 accelerometer. The X and Y axes are as the device is marked on the card.VCC to 5V pin.GND to GND pin.SCL to A5 pin.SDA...
Once the correct reading of the accelerometer is verified, you will need to set values of operation and you are going to insert this code in the visual engine performance code. Operation will be visually checked by the LEDs before connecting to the the...
Cut out or have board made.Install 4 x 0805 10K resistors on inputs, add 1 0603 1uF cap , solder in ATTINY 2313, add headers.Switch is optional, doesn't do anything in code yet.Program it! Wire in 5V power and switches, connect PUL to Pulse Input, DIR...
Get a piece of 3.5 x 8.5 form board or or you can use cardboard if you use cardboard you will need 2 3.5 x 8.5 just glue them together to make one solid piece.Lay the short tubes on the sides of the board and the long tubes across the top to form the...
Connect the power, signal, and ground wires between the Raspberry Pi and relay board. Connect the relay board output to act as a switch on the +9V coming off of the 9 volt battery. Once that is done, connect the 9V battery to the rocket igniter.
Add the HX711 sensor board to the Apitronics Bee.Connect the 4 wires from the scale to the 9-pin plug that passes through the weatherproof enclosure. These wires should be connected on the inside of the enclosure to E-, E+ (for excitation + and -) and...