Build the hardware:- Make/order the DSI Shield PCB.- Solder it!- Check the BOM, as not all components should be mounted.- Make/order/design an adapter board for your screen.- Connect the two boards together with the LCD. Power the system through USB.-...
Step 6 - Get your top graphics printed, or if you can paint the top. Your choice. If you choose to do graphics like I did, you will want to have them printed on a latex inkjet, using a quality self adhesive vinyl, with a polycarbonate...
Launchpad-Mame-Control TI Tiva C Launchpad firmware for Mame USB arcade controls adapterThis project is intended to design firmware for the TI Tiva C Launchpad development board to enable it to be used as a USB gamepad/mouse adapter for arcade and other...
Since the boards are hand made, it is very difficult to make the sizes of each module exact. This is why I cannot provide measurments of the casing or the front panels. Those also depends on the material used.See project logs for more details
Connect driver boards with ribbon cables. 7-segment display boards and led board uses 10 wire cable, 14-segment displays use 12 wire cables.Note that there is no 12 wire IDC plug, so I used 14 wire plug and left the last two wires unconnected on the...
Solder wires onto the Blue, Brown, Orange, and Yellow wires, plus GND / VCC (Red and Gray). Solder to a 6 pin female header. (Or, if you have enough room inside the controller, you can use the last couple inches of cable, and just solder...
Solder up the AVR + regulator onto a perf board, according to the schematic. Include programming headers (MOSI / MISO / SCK / RESET) and a 6 pin breakout for the PS2 controller wires you soldered last step.The schematic for this is below:
To get a good idea how we made the electrodes, you can read the project update entitled "The Hand Thingie". If you want to use the same sensing set up we used, this worked well. Any sort of Object that is fairly ergonomic and can have the...
Cannon code- #include "Servo.h" // include the servo library Servo armServo; // servo to raise the arm Servo cannonServo; // servo to recoil cannon // these constants won't change: const int triggerSensor = 1; // the sensor is connected to analog pin...