Close

163 Results for "3D printing"

  • Build the control box
  • Instructions     from Nuclear Magnetic Resonance for Everyone
  • Any of the components for the control box can be exchanged for another part. The Behringer sound interface has an input port for 1/4" connectors as well as XLR. A three state (on1,off,on2) switch is recommended as the off state is often useful for...

  • POST STROKE SPASTICITY REHAB HELPER

  • Instructions     from ReHubJr Rehabilitation Helper
  • Bill of Materials We use in the project the components No Q Name Description 1 2 Controller Arduino nano R3  2 6 Tenzo Bridge Pressure Sensor Scale Module 3 6 ADC fo Tenzo Bridge HX-711 4 12 Servo mini SG90 Servo mini SG90 9g Tower Pro 5 0 Blue...

  • Propulsion System: Motors
  • Instructions     from Archelon ROV
  • The motors of the Archelon ROV are developed through the modification of 8 Rule 800 GPH bilge pump motors.  Install three-blade 60 mm diameter plastic model boat propellers with bilge pump shaft adapters onto the bilge pump motors. The...

  • Step 1
  • Instructions     from 8 legged spider robot
  • 3D print all the components :2 x hinge high left2x hinge high right12 x hinge2 x left aft leg2 x left front leg2 x left midle aft leg2 x left midle front leg4 x long hinge2 x movable plate holder 12 x movable plate holder 22 x movable plate holder 32...

  • Attach tubing to cages
  • Instructions     from Nicotine Vapour Exposure Chamber for Rats
  • Using the same Heatshrink process as Step 11 and 12, Heatshrink the loose ends of the plastic tubing to the nozzles that you 3D printed. Once you have this done you should have something that looks like the image below. Drill a hole approximately 1cm...

  • Mesh pads
  • Instructions     from DIY mesh conversion of a simple drum set
  • The pads are based on toy drums which already have most of the needed bits (like rims and screws) and what missing, I 3D printed.List of main steps: Preparing shellsTrigger and "electronics" (see another instruction)Rim "mufflers"3D printed partsFinal...

  • Pnumatics
  • Instructions     from Manual Pick and Place SMD Vacuum
  • For the pnumatics I 3D printed some standoffs so that they would not be resting directly on the case. This was mostly done because of the length of fasteners I had and also to dampen the noise produced by the vacuum pump. I plumbed the punmatics as shown...

  • The Fit
  • Instructions     from Not the typical masks
  • None of existing mask designs fit people's different face shapes. The surgical masks are leaky. The N95 types can be uncomfortably pressing against people's faces and the wires around the nose areas can still be loose. Instead of the cookie-cutter one-size-fits-all...

  • FireCoates
  • Instructions     from FireCoates
  • Optional 3D Printed Jacket Module CaseDownload the Base and Top to the case and print them on your favorite RepRap OpenSource 3D Printer. It should come out looking similar to this(colors may vary ;) ):The headphone jack hole may need to be cleaned up...

  • Assemble the swivel
  • Instructions     from Ceiling Mounted VR Support Rig
  • You'll now be assembling the rest of the swivel and coupling it to the ceiling brace, as shown in the following image. Take the 3D printed square spacer for the ceiling brace (row 16) and insert it into the brace. It is highlighted in orange below. Take...
Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday