Start with the fun bit! Here's a short Organiser II buying guide I produced myself - consult the websites for more detailed/informed insights... There are four models of Organiser II - all should work with this project. I own two Organisers - a 1988-89...
Reattach the membrane and also put everything else back into place. From the outside, the pump should look exactly like before, so mark it as a vacuum pump if you like.
Just laugh and play outside, with your augmented reality. Play virtual games outside instead of inside. Design toys or cars, fix real cars and never be afraid. Look at the sky and be able to see the real stars with a name beside it. Laugh and cry when...
In the arduino code set your WiFi credentials char wifissid[] = "ENTER YOUR WiFi SSID HERE"; char wifipass[] = "ENTER YOUR WiFi PASSWORD HERE"; Normally, the signal strength is displayed in dBm. But for a non techie person, the signal strength in terms...
Locate a spare out-of-the-way spot inside the movement that can accommodate the board. For the Quartex Q-80 movement, the best place is between the latch and the sub-assembly on the side opposite where the coil and battery terminals are.If the board...
Server Controls:The real tricky part here is starting VLC from the web, as a user, that will allow outside connections.My solution was to configure Apache to have user pages. I then placed the server controls in /home/username/public_html/cgi-binhttp://httpd.apache.org/docs/2.2/howto/public_html.html...
make or find a pretty box. over build it.a round box is cool, but a bit of a painmake your box hard to open unless you have neat toolsthis box is planned for being epoxy and screwed to a wall outside
Start at the outside bottom of the hemisphere, and make a “ring” of triangles, leaving one missing wherever it is that you would like a doorway. It is helpful to place a panel there and remove it, just to check alignments. Triangles will...
I bent the LED strip in half as close to the PCB as possible, and taped that to the outside of the roll. I then taped circular pieces of cardboard to the ends to block light and taped everything together with significant amounts of [inexpensive] masking...
Finally, connect the LED strip to the OUT section. Keep in mind that the GND wires of the IN and OUT are next to each other, and the 12V wires are on the outside of the module.A job well done, great!
Pry the lid off the movement. Pull the plastic gear train box out carefully. Do not allow the black square gear retainer to fall off the shaft and take the outside gears with it. Also, don't allow the battery contact prongs to fall out of the bottom...