Using a #2 phillips screw driver, remove the two mounting screws from the stack light. Fish the wire bundle through the large hole in the top enclosure piece. Use the two mounting screws to attach the top enclosure to the stack light.Trim...
The top two sheets of the laser harp don’t hold any lasers. First, the corner brackets are pressed into Layer 2. The orientation of the brackets matters because of how they fit into Layer 3 in the harp. Layer 1 is then pressed into the top...
I printed the SVGs to the correct size glued these onto the top of the acrylic and used this as a template to cut out and drill. This is easy for acrylic as it has a protective sheet to peel off any. Wood might leave a mess.
Top half of case. There are two ground wires on the LiPo charger. Stretch one over to the large circular area of the keyfob. (See photograph in Step 14.) Cut to length, strip it and solder it to the circular area (in common with the black wire of...
I used some scrap material I had around my workshop both around 5mm thick. You can either print the SVGs I supplied and use these as a template or mark out the dimensions shown above.
Top half of case. This was a change made later. To assure proper keyfob transmission, solder a ceramic capacitor (0.33 to 1.0 uF) between the arm of the battery holder and the large circular area of the keyfob. The easiest way is to trim the capacitor...
An alternative way for a small footprint of the elements is to cut the elements in half and then drill your center hold in each piece. This allows the elements to fan out and collapse into a half the diameter of the above method. Either method works,...
Use a drill to put holes 1/2" inwards from the corners of the top piece. Use a jigsaw to connect the bottom and top hole on each side. Then, use the jigsaw to cut a rectangle that is 2.5" wide towards the middle of the top piece. This gives space for...