Adding ubus PermissionsIn order to run ubus commands outside of the terminal, you must first include the functions in the ubus permissions file. Go to the permissions directory: cd /usr/share/rpcd/acl.d/In onion-console.json, add your ubus functions...
Place the Lisiparoi on the Berry Black case in the place you want it – make sure you allow enough room around the outside so it is not too close to the edge. Draw around the Lisiparoi with a pencil – this will be our reference point so we can work out...
Carefully cut out the old battery area to get more room for wiring and components. Leave the nut, walls matching the battery door, and some corners for the outer edge (so the door won't fall through). If you don't need the whole battery area space, you...
Place the back panel writing-side down on a flat surface. Thread the 4 1" bolts through the corners from the bottom (the outside of the finished case). On the bolt nearest the GPIO header cut-out, place the 3/16" standoff and on the other four, place...
I simply placed it in the box and used the excess wires to anchor it. This has so far been stable enough. Gift-wrapping paper was used to decorate the match box. I put a small hole in it, so that the LED light is visible from the outside.
Use the nylon screws and hex nuts to secure the photo interrupter boards to the inside of the 3D printed cover and bring the wires to the outside of the cover using the hole in the top left of the housing.
First I prepared the transparent white LEDs by griding off a bit of the tip and by slightly rougheing the outside of the remaining housing to improve the emission to all directions. Then I soldered them to the two hexagons. One of the hexagons...
Here is the most difficult part. You will need to de-solder the volume, power, and aux\Bluetooth switches from the amplifier. The volume knob will just be extended to reach to outside of our cabinet. The power and Aux switch will need to be wired to...
TBD - Will include pictures and more detailed instructions later.There are loops evenly spaced all over the wearable assembly. Simply sew the assembly in place (with the neopixel lights pointing towards the outside world, so to speak).I found that I only...
Cut the rubber band and tie an overhand knot in each end.Bend the end of the Forehead Band horizontally to get the V slit to open up enough to insert a knotted end of the rubber band. Bend it the other way and flatten, then pull gently on the rubber...
Insert fibers into four corners and align their edges with inner case edges. My fiber is a shielded 1 mm plastic core with a 2.5mm outside shield diameter. You might need to change the CAD files if you have a thinner or thicker fibers....
Move the slide switch back to chrg. Plug a microUSB cable into a cellphone charger and into the charging port on the outside of the top half of the case. The charger should light up. It will be red until the battery is fully charged, then turn green....
Grab three M3x12 Flathead bolts and three M3 hex nuts. Before: Install the fan so it blows into the print. Put the Flathead on the inside of the print and the hex nuts on the outside. After:
One final step is now fixing the volume Knob. The screw that comes with the EC11 Rotary encoder helds the PCB in Place. Add the two screws on the side to keep the Glas of the lamp in place. On the outside firmly press the Aluminium Volume Knob on the...
Peel back the paper covering the adhesive and press it on the outside of the door 6 inches above the lock.Maintain light pressure for 30 seconds to ensure it remains attached