TSOC_PSoC4L InstructionsThe TSOC_PSoC4L comes preprogrammed with a command line interpreter (CLI) that runs on the enumerated USB COM port by default. It can be changed to run onother ports interactively.Immediately after plugging in the USB or Li-Po...
Adjust everything, tight the needed screws and beltsAdjust the top and bottom carriage, the Braille stylus of the bottom carriageneed to slighty enter in the anvil of the top carriage.Mount the electronic board with driversWire the 12V alimentation Adjust...
For this project I used Arduino IDE for programming my Wemos. It's the easier way if you've already used an Arduino before, and you won't need to learn a new programming language, like Python or Lua for instance. If you've never done this before, first...
For this project I used Arduino IDE for programming my Wemos. It's the easier way if you've already used an Arduino before, and you won't need to learn a new programming language, like Python or Lua for instance. If you've never done this before, first...
Before starting with the Node-RED flow, we must establish some configurations in the SIMATIC IOT2000. Please, follow the steps below carefully to ensure the right functionality: Package manager: Go to the opkg directory: cd /etc/opkg 2. Edit the...
Hang on my Padawan, we come closer to the functional Lightsaber Game Controller, now that you have previously downloaded vJoySerialFeeder, we must configure our controller on it. After following the wiring diagram of our circuit to Arduino, you re going...
As soon as you open the { Pimp my 3D-Printer WIN} folder, you will see the following directory: There you will find our instruments, the zither, ukulele and güiro, each in the form of a Pd patch. We will first explain how to control...
Above is the Y and Z axes attached to the X axis. Firstly, the Y axis is attached onto 2 lengths of 50 x 50 x 3 angle, which need to be cut to length. Do not weld them on at this stage! The best way to do this was to completely assemble the Y and Z and...
[Figure: Removing Y-Axis] [Figure: Salvaging Stepper Motor] Finally, we can start assembling our 3D printer. And by assembling, I mean disassembling. My tutorial assumes you are starting this project with a functional fully assembled FDM 3D printer...
Requirements Oasis controller is written in Python. Right now the right Python with libraries is required to run Oasis controller. Install the right python and libraries before running the Oasis controller software. Python 3.6.2 PyQT5 (pip3 install PyQt5)pyserial...
Use sandpaper and lubricating grease.x2 Y printed bearingsx1 lubricating grease pot The bearings have to slice very easily. Then slice x3 M6 coller nuts at the oposite chanel from the bearings and x2 M6 coller nuts on the top. Like the picture....
Los archivos .f3d están en el comprimido "GripperF3D.zip". Utiliza dos Servo MG90. El ensamblaje es bastante simple, y se puede ver en el archivo de ensamble incluido.
This is the EleksMaker® EleksLaser-A3 Pro with the laser module removed. This is a belt-walk system (belt is stationary and acts as a rack). This has been raised up 75mm to keep the electronics underneath and MDF acquired for a base and work...