Close

19513 Results for "《〈 문의 OIO↗5793↗7458 》〉 셔츠룸ヒ 《〈 문의 OIO↗5793↗7458 》〉 ㎛beforehandム셔츠룸후기셔츠룸후기╇pen 선릉셔츠룸셔츠룸가격 셔츠룸‰강남셔츠룸㉦nestㅳ"

  • Not quite modular yet... sunk cost?

  • Oh man... so I've been trying the wide angle camera and I'm just disappointed honestly... I guess what do I expect you know? You can't compare this to a real camera eg. Sony Alpha Nex-5n (APS-C camera from 14 yrs ago). I went ahead and ordered the standard...
  • The first one!

  • Project Log #1 Little sparks for a gift - sometime in 2019 I think. When I moved to colorado about 5 years ago I got a job in PCBA assembly. It sparked a lot of on and off the job learning about circuit boards and their manufacture. In another lifetime...
  • PCB Bringup

  • I received the PCBs from JLCPCB which look great, however I have found some issues with the board: The TPS61023 boost converter IC I selected will operate down to 0.5V input, but I managed to overlook the point where it states that it requires 1.8V...
  • Photos

  • Front view: Rear view: Bottom view, feet; Two screws were hidden under the round calibration labels. Bottom view, two rear screws hidden under the feet: Side view, pull the sticky bits off: Complete top board: Ooh look, a 68B09E. The 63B40 is a programmable...
  • PSU #095, a CPX400SP

  • This is a switch-mode PSU, so the mains is rectified to around 400 volts DC inside. Extra care is required to avoid touching this dangerous part of the PCB. This can be remote controlled by GPIB, RS232, USB or Ethernet. The user manual is here: CPX400S+SA+SP_Instruction_Manual-Iss9.pdf...
  • Photos

  • It is big... The daughter board on the left has a ROM that seems to hold the patterns. It uses an SAA1043 universal sync generator. A module can. An 8085, 8155, and EEPROM. The 8155 contains 2K of RAM. 4012 110 10812 Digital Board For PM5515: 4012 110...
  • EXTRA UPDATE - DANGEROUS?

  • READ THIS:● Some of you guys on the community commented that the AC high voltage clearance is too low. YES, YOU ARE RIGHT! I usuall add copper plane to all my PCBs and that was a mistake made ina hurry. So even if you see a bad clearance in the...
  • What have I got?

  • The first step, after wiping-off the accumulated grime and surface corrosion, was to assess what I have. Within the very large - and very heavy! - case were four cards - an MZB-3 CPU card, a VDU-2K (composite video only) 'graphics' card, an FDC-1 Floppy...
  • Time to order the hardware

  • Since I now can provide moisture sensor values via MQTT to OSPi, it's time to order a board and the other necessary hardware.  As I understand, there are plans to integrate MQTT subscriptions into the OpenSprinkler firmware. I hope that this will...