Close

36997 Results for "∇ 최저가 Ò1Ò《⑤⑦93》74⑸⑻ ∇신사역몰디브ⓟ몰디브주대totally강남몰디브강남몰디브몰디브셔츠룸peculiar 몰디브셔츠룸Yて몰디브셔츠룸carelessly"

  • Hack Chat Transcript, Part 1

  • Dan Maloney12:00 PMOK folks, here we go! I'm Dan, I'll be moderating today along with Dusan as we welcome Quinn Dunki back to the Hack Chat. We had Quinn on a couple of years ago to talk about machining in general, but now we want to get into specifics...
  • Display

  • I started wiring up the Memory sub-system board and realized quickly that I needed the display board to show the state of the various registers.  I first had to create a backplane to connect the boards into.  The backplane carries all the signals...
  • Blue Board #01

  • BlueBoard#01 is... A 100mm by 100mm board that's for prototyping and one-off projects that use SMT and through-hole components.  An earlier prototype Features 19 standard footprints2 x 1.27mm pitch footprints (10 pads, 28 pads)1 x 0.65mm and 0.635mm...
  • Enecsys Microinverter Monitoring

  • 1 Intro The Enecsys Gateway is a Zigbee gateway allowing communications between the Enecsys microinverters and their monitoring backend. The Enecsys company is unfortunately defunct since 2015 and their DNS domains have been taken over by a UK enecsys...
  • Mnemonics list

  • Here, mnemonics for all instructions are listed, with short descriptions: ALU instructions (link to machine code description): All ALU instructions perform operations only on General Purpose Registers All ALU instructions taking 2 bytes in memory. instructions...
  • Beefy Stepper

  • (Here's the complete description - sorry for some redundancy.) There are many single chip bipolar stepper motor controllers. These can supply one to two amps and work great for most NEMA 17 and smaller motors. But I wanted to control a long NEMA 23 motor...
  • Transcript 5

  • hamsterdaveJun-7 1:24 PMField day, 2 weeks, if you’re interested, go! zonker.harrisJun-7 1:24 PMJust a note that the U of Oregon has a ham club (N7DUX...) KevinJun-7 1:25 PMMic shyness is a thing and it goes away over time. Don't let it put you off....
  • PD150

  • The story behind this project Every now and then I would find the need for a differential probe. I’d end up using a high voltage diff probe, which you've probably seen lurking around most electronics labs – the ones housed in a large rectangular box...
  • SPI-Flash Test

  • I bought the 8 Mbit flash P25Q80H-SSH-IT at lcsc.com for $0.10 if you buy 10. First I tried it with this circuit on a breadboard: The numbers are the pin numbers on a Arduino Nano, which runs with 5 V, so I used the resistor dividers for scaling...