27106 Results for "↘ 최저가 Ò1Ò〈⑻⑷89〉83Ò⑥ ↗ 쓰리아워ㅾ Йlife강남술집정보ħ쓰리아워레깅스룸강남쓰리아워７┢강남술집정보indignation 쓰리아워레깅스룸ケ쓰리아워ı㎃outside"

Go outside and do some observing
Instructions from Pi Planet Finder
Hook your finder up to battery power, take it outside, and have fun observing!

DMX-84: Calculator-Controlled Lights
Instructions from DMX-84: Calculator-Controlled Lights
Now, go to the source folder and navigate to src/ti. Send the file DMXDEMO.8Xp to your TI-84 using your preferred linking program. If you don't know how to do this, read http://tiwizard.com/transferring-programs-to-your-....Note that there is also...

Digital Assistant & Networked Thermal Priter
Instructions from Digital Assistant & Networked Thermal Priter
set it up on your network, forward your ports if you want to use outside of the network

SWATTER HACKING
Instructions from SHIVA HANDS
Assemble the handle making sure the ends of both the soldered wires are outside the handle.

Some custom label for the outside
Instructions from The Black Beast

Connect the Relay
Instructions from Outdoor Relay Control
Connect the Relay to let the Outside Automation activate the connected device.

Portable environmental monitor
Instructions from Portable environmental monitor
Populate the board. You will need some good experience with 0805 SMD soldering, and some tools like soldering iron and hot air rework station. Start with the bottom side, with the microcontroller, the other ICs and finally the small passive components....

Reset, go outside and have fun
Instructions from India Navi
After downloading the firmware to the ESP32 you can insert the SD card and press reset. You are now good to go outside.Once outside the display should update with the current time and position. The position might take a minute or two to update. As long...

Phishing WiFi hotspots with captive portals
Instructions from Phishing WiFi hotspots with captive portals
Upgrade the firmware (this will reboot the system and delete all changes made outside of /etc folder): oupgrade -f

Traffic Signal LED Matrix Display
Instructions from Traffic Signal LED Matrix Display
Remove the back section of the case, held on by a ring of screws about halfway from the center to the outside of the circle.

Reassemble
Instructions from P1 - Solenoid 3-way conversion
Put it all back together. If you will be applying pressure to port 3, epoxy a hose bib to the outside.

Place LEDs
Instructions from Scary Pumpkin with motion detector and movements!
LEDs should be located in the front so they cannot be seen from outside, just the flooded light.

Universal Controller
Instructions from Universal Controller
Glue a 3xAAA battery holder to the outside of the case. Connect the power switch in series with the positive side of the battery. Re-assemble the case. You should now have a self contained unit with batteries on the outside and a switch....

Put the HV supply in an enclosure
Instructions from DIY Scintillation Detector
Get a metal enclosure, drill holes for 2 connectors - 1 BNC and another one of your choice for 5V power.Drill another 2 holes on the other side - one for the Enable Switch and one for an optional multiturn 5K potentiometer (do not populate footprint...

1
2
3
4
5
>
>|