Solder female headers on the side of the Feather board.You can decide if you would want the headers to go looking up on the same side of the keys so the Feather will be on top, but can also be attached to the bottom of the featherwing by connecting the...
Solder headers to OLED Wing. Do not solder Wing to Feather yetMake connections from NeoPixel Strip and Gas Sensor to OLED WingWing to FeatherGND and 3VSCL and SDA to connect I2C bus Buttons: Button A - A8 Button B - A7 Button...
The Adafruit Ethernet FeatherWing can be used with any Feather Board, and the sample code provided below was designed openly to fit the series, so choose your Feather hardware freely. To learn how to setup the Feather boards reference to the Adafruit...
1. Battery + USB Power: Whereas other Feathers boards can run direct from 3.3V USB or battery, the Feather FONA manages the battery and USB power differently. With this board you must have a Lipoly/Lilon battery plugged in at all times. For more specific...
Solder straight male headers to the Adalogger board, instructions here: https://learn.adafruit.com/adafruit-feather-m0-adalogger/assembly Solder six 90 degree headers from Vin to CS pins on the Memory Display. You can plug the 6-wire...
Use the micro-USB wall wart to power the Feather, and the setup is complete.The Meditation Pod sculpture premiered on display at Centennial College and has moved to a cute Toronto coffee shop since then. Check out its rain sounds in action:
Component Needed: Huzzah FeatherTFT FeatherwingM2.5 ScrewsKitchen Case and Cover 3D files3.7 Lipo 500mAh batteySmall dab of mounting puttyGlueTactile button (7mm height)On/Off SwitchUSB wall charger and USB cable0.1 uF capacitor, 200K resistor, 1M resistor...
Now it's time to figure out a way to get it on your wrist. I 3D-printed a little bangle, and glued the Feather onto the printed base plate. To use the decorative scales, clip the side of the opening and thread the wires through. The biggest scale goes...
Use a rubber spray coating to water-proof the electronics case - this will take up to 24 hours to cureOnce this is complete, drill 6 holes into the case for the sensors and the batteryScrew the button into the top of the Electronics CaseSolder the 2-pin...
You'll need: Arduino / Feather H bridges / motor shield / motor wing Owi arm / Servo based robotic arm LEAP Motion Wires, soldering paste, soldering iron. In the software theme youll use the arduino IDE and processing, both are free and a...
The Arduino IDE code is given in the files tab. You will first need to configure the Arduino IDE to detect the Adafruit feather. You will also need to install the following libraries: Adafruit MPR121 Adafruit BluefruitLE nRF51 Start by opening...
If you are going to use the low-profile female headers on your Feather boards, you can put the plastic back on the pins, since they only need to stick out very little. If you are using regular headers, leave the plastic off, this way the pins can go...
Before you can start uploading your own code (firmware) to the nRF52, you'll need to setup the Arduino IDE. Adafruit has already written a pretty comprehensive guide so I'm not going to repeat it here. Make sure you complete this step and uploading an...
You can find every information about Feather MO Adalogger in: https://learn.adafruit.com/adafruit-feather-m0-adalogger/overview I have used all pins of Feather and I would like to have more pins available. These are the connections of the set: Pin00-...