0%

0%

amol0172

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

This user joined on 02/23/2021.

Projects I Like & Follow

Takes 3D surface scans at close range. It is simple to construct as it uses off the shelf hardware and software.

3D scanner

Hackaday Prize 2019

LP3D is an (almost) fully lasercut, low component count 3D printer with all linear motion components cut directly into the frame.

LP3D: A fully lasercut kit 3D printer

https://www.youtube.com/c/longtechnical More About LongTechnical » How to Program ATMEGA 8,16,328 Attiny and Fuse Bit Hi friends. Tod

HOW TO PROGRAM ATMEGA 8,16,328 ATTINY AND FUSE BIT

Add a second brain to your Arduino Mega

RetroShield for Arduino Mega

Hackaday Prize 2019

This projects converts a Bobby-Car (children's ride-on toy) to electric by using 4 Hoverboard motors, VESC controllers and an ESP32

Electric Bobby-Car

ESP32 runs FabGL to produce VGA display

ESP32 VGA PS/2

land-boards.com

Make a Raspberry Pi replacement using a Cypress Semiconductor Programmable System on a Chip (PSOC 5)

Not Quite Useless Raspberry Pi Replacement

land-boards.com

Add Bluetooth speed output to treadmill. Arduino on ESP32 and Treadmill Speed sensor. Zwift compatible with realtime Webpage stats.

Add Bluetooth to Treadmill

DIY Ethernet board for IBM PCjr

PCjrNet

Here we will establish a connection between the HC-05 ( connected to ATmega8 ) and an android Bluetooth app to blink a LED.

Interfacing HC-05 Bluetooth module with ATmega8

electronicsforgeeks

This project has an esp8266 giving Wi-Fi functionality, LoRa module, 1.8 inch TFT display and buttons. You can make LoRa Remote or messenger

LoRa Remote Control Messenger With a 1.8" TFT

akarshagarwal98

Hackaday Prize 2019

Omnidirectional 3D printer for... Houses?

Omniprinter - #Swarm 'Large Scale 3D Printing'

How to generate frequencies below 10Hz using a PC, an amplifier, and a handful of components.

Extreme Low Frequency Signal Generator

Building OnStep with Kicad (with all necessary footprints and 3d image files).

My OnStep Kicad Project

Michael O'Toole

This project is about building your own stopwatch using the Arduino board and a few other components.

Arduino Stopwatch

hIOTron hIOTron

An Open Source electronic blood pressure monitor research platform with Oscillometric method, based on STM32F4.

A-fib Detection Blood Pressure Monitor

Big clock from the 90's overhauled to obey an ESP32 instead of its old motherboard. Lots of possibilities for display. Very clicky.

IOT Mechanical Clock with Bluetooth App

Buy the Raspberry Pi Zero W V1.3 Development Board at the Best Price only at Robu.in

Raspberry Pi Zero W V1.3 Development Board

View all

Bits