Close

819 Results for "≡ 예약문의 OIO《⑧④89》83ⓞ⑥ ≡선릉드림레깅스룸☜드림레깅스룸dreary강남드림레깅스룸선릉드림선릉드림레깅스룸distinct 강남드림㈓ ゲ선릉드림레깅스룸선릉드림summit"

  • Open Source Science Tricorder
  • Instructions     from Open Source Science Tricorder
  • http://www.tricorderproject.org/arducorder/chipkit-mplab-ide-0023-arducorder.ziphttp://www.tricorderproject.org/arducorder/chipkit-mplab-ide-0023-arducorder.zipStep 3: Constructing the CaseThis beautiful case is constructed from laser cut acrylic --...

  • Cheap PC PWM Fan Controller
  • Instructions     from Cheap PC PWM Fan Controller
  • Assuming you now have all of the parts available at your disposal (plus a few spare just in case - you know how sods law is). Start with looking at how you are going to lay out the parts and wire/solder them up. I probably went overboard by using...

  • DIY Hot Air Solder Pencil Iron
  • Instructions     from DIY Hot Air Solder Pencil Iron
  • This is quite simple, first you use the Hi temp silicone to seal the metal to plastic junction of the iron.  Leave that to set overnight.Cut off about an inch of the 3mm brass tubing, try not to pinch it closed. If you do use the soldering iron...

  • Infinity Mirror Clock
  • Instructions     from Infinity Mirror Clock
  • The clock is primarily made up of the following: 2 pieces of 8mm plywood (600mm x 600mm) - needs to be cut as per the schematic above1 piece of 18mm block-board (600mm x 600mm) - needs to be cut as per the schematic above. Please be careful with the...

  • Smart Cap
  • Instructions     from Smart Cap
  • Step 1: Preparing the head mounted display enclosure Cutting the sun board sheet for preparing the head mounted display enclosureIt is necessary that the display needs to be cut off from all external light sources to ensure a sublime viewing experience....

  • Insta-Ego Head
  • Instructions     from Insta-Ego Head
  • Set up your cloudBit if you haven’t done so already. Instructions for setting up the cloudBit can be found here. 2. Prepare the tilt valve: Unscrew the tilt valve from the tank. Carefully cut the black rubber nozzle off of the valve. Cut a piece...

  • Animatronic Hand
  • Instructions     from Animatronic Hand
  • Upload the “Rock Paper Scissors” sketch onto your Arduino. The sketch file can downloaded from this page in the "other files" section.2.  Create the circuit.3.  Build the robotic hand. Laser cut the attached file “robotic...

  • DIY evaporative cooler.

  • Instructions     from DIY evaporative cooler.
  • Basically I set this up in about an hour.   I put a foot deep hole in the flower bed and gave the antenna mast a moderate soil base to keep it from moving.  I also used a piece of yellow twine and and two small penny nails to keep it from...

  • Toner Transfer with Kapton
  • Instructions     from Toner Transfer with Kapton
  • On the same sheet of paper place tape over the printed image of your traces so that it is completely covered. If you have to use more than one piece of tape, make sure that there isn't any gap between the strips. You can see in one of my images that...
Going up?

About Us Contact Hackaday.io Give Feedback Terms of Use Privacy Policy Hackaday API

© 2024 Hackaday