Close

4954 Results for "《〈 문의 OIO↗5793↗7458 》〉강남초원의집㉩⅓everythingァ강남유흥강남룸㏁evidently 강남초원의집강남더킹 강남더킹‡강남룸Ⅹfaintly㈆"

  • Building the AUV - Internal

  • The internals of the AUV performed the heavy work of actually taking water quality measurements and controlling the submersible's buoyancy. Evidently, it also required a sophisticated mechanical design to fit the necessary components into the confined...
  • Meteor Hunter

  • Once you have everything hooked up make sure you have python 2.7 installed and OpenCV (here).
  • 1Charger

  • Time to think inside the box...1. Flash ATtiny without CALIBRATION defined ( see step 4 )2. Verify everything works as expected3. Assemble project box and solder connectors.\(^_^)/ DONE !
  • Assembly

  • Solder the sensors to a foot or 2 of wire and run them through the wiring hole in the sensor enclosure. After you’ve mounted the relay shield into the enclosure, connect everything up to the screw terminals as-labeled. It should look something like this...
  • Single Chip AVR BASIC Computer

  • Completed PCB: Once I had all the components and had received the PCB, I assembled it and carried out some basic multimeter tests ensuring no short circuits were present (mainly ensuring no pins had shorts to the ground plane). No issues were present...
  • Assemble everything

  • 1. Cover the cell with Thread to make it bit not ugly.2. Place all the components on perf board before soldering to make sure everything fits under the board size.3. Solder NE555 ic with other passive components including the tactile switch, then solder...
  • Test....

  • Put the battery pack back together with the motor.Careful, the motor might be switched on!Switch on the dust buster and check if it is proper running. Check if all the cells are connected well!If everything is fine, check if the charging is working.Double...
  • Ultra Low Cost Electronics Kit

  • Buy everything from the materials list from Aliexpress. Try to group your purchases under one supplier as this will lower shipping costs. Get a case that is at least 9 x 7 x 3 cm, this is just large enough for the half size breadboard.Store all components...
  • Get Everything Together

  • You will need: - Male to Female jumper cables - AVR programmer (  I used Pocket AVR programmer from sparkfun ) - USB micro cable for the programmer -USB OTG cable -All 3D printed parts -M3 x 10 CSK screws -Silicone button pads
  • Materials You Will Need:

  • 1-NodeMCU ESP8266 board 1-PIR sensor 1-LM35 temperature sensor 6- 3904 NPN transistors 4-1n4001 diodes. 8-1k ohm resistors 4-5v relays 2-12v relays (can be replaced by 5v ones). 8-Terminal blocks Some wiring to connect everything and that's it.