0%

0%

Abenazio Júnior

Olavo tem razão!!!

Brasil

Following Follow me

Send a private message

Similar accounts worth following

Send a private message

Twitter

This user joined on 08/04/2022.

Projects I Like & Follow

A piezo inkjet printer built from scratch

DIY Inkjet Printer

dominik-meffert Dominik Meffert

Hackaday Prize 2019

This hybrid generator for drones is designed to get 10 times the flight time of a classic electric drone

HYBRID GENERATOR FOR DRONES

Released in late 2007 NAND Flash capacity was still very limited (4GB and 8GB MLC). But is it possible to replace the aging NAND Flash?

iPod Nano 3rd Gen MLC NAND Upgrade & Software Hack

hugo-melder Hugo Melder

3D printed toroidally wound axial flux permanent magnet air core motor. 3DTAFPM?

3D Printed Axial Flux Motor

colby-johnson Colby Johnson

2021 Hackaday Prize

Yet another overkill project. An attempt at building a portable and versatile GCS for robotics.

Robotics Ground Control Station

maximiliano-palay Maximiliano Palay

Easy to use Arduino Uno Shield to support your rockets from the ground!

WOOF Model Rocket Launchpad Computer V4

canine-defense-technologi Canine Defense Technologi

ModbusBox has embedded setup web-page. Yo do not require to program anything to connect any modbus RTU device to MQTT.

IOT ModbusBox

Emulate a small size ROM with a RAM and Arduino with Intel-HEX interface

ROM-emulator

fjkraan fjkraan

In this project, the objective was to build a FPV flying wing with over 700mm wingspan that could be printed under 24 hours.

3D Printed Flying wing FPV Drone

Pushing the envelope of artificial intelligence with deep fake electrical engineering and songbird identification

Deep Fake Birdsong

kelly-heaton Kelly Heaton

The Icarus is a FeatherWing-compatible (Feather) board with the nRF9160, made for easy cellular IoT development.

Icarus IoT Dev Board nRF9160 (LTE-M, NB-IoT, GPS)

How to make an IoT-based Smart Home with Blynk 2.0 using NodeMCU ESP8266 to control 4 home appliances with real-time feedback.

Smart Home Using NodeMCU ESP8266 & Blynk IoT app

Maakrapu (Finnish, Landlubber / Land Crab) is an electric art-vehicle.

Maakrapu

arno-munukka Arno Munukka

Underwater drone i-GOR + Float station

UNDERWATER DRONE i-GOR

roman-weitendorf Roman Weitendorf

Ambient LED artwork created by playing an animated GIF in extreme slow motion with high LED refresh rate, and interpolation between frames.

Continuum - Slow Motion LED Art Display

louis-beaudoin Louis Beaudoin

This is a 3d printing modular pulley system.Total mechanical advantage is 8:1. So, we can lift a mass of 80 kg with a 10 kg pulling force.

3D Print High Strength Pulley System(Block&Tackle)

Smart Home IoT Gateway supports CAN, RS485, Lora, Zigbee, Wifi, Ethernet, Input and Output control

Smart Home IoT Gateway

thuan-le Thuan Le

This project is an ambitious one, where we want to use some of the most questionable parts of the internet, comment sections and chatrooms,

Generating Art From Comments

View all

Bits