close-circle
Close
0%
0%

Muth

Always with the hope to make something and not just use something.

location
France
Send a private message
Similar accounts worth following
close
muth
View all

Share this profile

Share

Bits

Dr. Cockroach wrote 02/06/2017 at 18:42 point

Good afternoon and thank you for following my cardboard computer project :-)

  Are you sure? yes | no

Muth wrote 02/07/2017 at 09:16 point

You're welcome, it's an impressive work !

  Are you sure? yes | no

monoroto wrote 06/30/2016 at 02:00 point

Hi Pierre, thanks for your support on my project with Polapi using a pi zero board and nano printer. I ultimately ran into a dead end with the camera starting and stopping when I run the program. At this point I am going to redo without using the piTft viewfinder using a CUPS, but if you happen to come across any ideas, please let me know. Thanks. Marco

  Are you sure? yes | no

Muth wrote 06/30/2016 at 15:49 point

Hi Marco,
Sorry for the delay, I received the PiZero only yesterday. I found the camera works only with the last raspbian release, which is probably different of the one built for the PiFTF for the moment. 
I'm facing some piZero strange behavior when I want to configure a wifi usb key. I'll try to solve that and let you know if I can get at least the printer and the camera working.

Cheers !

  Are you sure? yes | no

monoroto wrote 07/04/2016 at 18:29 point

Hi Muth, you need to edit /etc/wpa_supplicant/wpa_supplicant.conf and add 

network={

SSID= "NETWORK NAME"

psk= "password"

}

in order to access wifi.

I was able to get the camera to work by doing rpi-update using 

sudo SKIP_KERNEL=1 rpi-update

Now I am getting camera preview when I boot up but still getting camera end. When I do raspistill i get mmal: failed ENOSPC message.

Do you have an updated jar file reflecting any updates? Thanks

  Are you sure? yes | no

kelu124 wrote 02/29/2016 at 08:38 point

Merci pour le follow pour le dev board d'imagerie par ultrasons - et surtout félicitations pour le boulot autour du thermal printer, ca m'a motivé pour en essayer un =)

  Are you sure? yes | no

Neil davis wrote 11/19/2015 at 20:43 point

Pierre. It works! 

I'd like to thank you for your amazing support! I have a working camera to fascinate my children this christmas! The alternate jar files worked a treat.

  Are you sure? yes | no

Muth wrote 11/19/2015 at 21:02 point

You're most welcome ! 

  Are you sure? yes | no

esot.eric wrote 11/19/2015 at 00:13 point

Howdy! Thanks for the skull/follow!

  Are you sure? yes | no

frankstripod wrote 09/19/2015 at 17:12 point

Thank you for following my camera project! :)

  Are you sure? yes | no

Become cool instantly

Create your Hackaday.io profile like Muth and many others